Klantbeoordelingen voor VEVOR Transmissie Krik, 750 kg Motorkrik, 85-170 cm Hefbereik Motorblok Transmissiekrik, 2-traps Hydraulische Transmissie Krik, Vrijloop Hydraulische Krik voor Auto Workshops Auto Transmissies, Rood

Low quality. Does work. Missing parts and hardware. Slow.

They've changed fasteners that don't match the instructions, and the side leg brackets are now held on by lare socket cap screws. Look like you need an M12 hex drive not 100% sure of that as I haven't dug out my set. The casters are metal and will marr and scratch floors. I bought some M12 stem heavy duty poly castors to replace them with. Also would be nice if it had a rubber pad on the jack surface.

Upper cradle of the Jack is poorly made

The top needs to be made a 1/4 turn different. And the table needs to angle 2 ways not 1 .

I can’t complain much for the price, but it slowly bleeds pressure off and drops the transmission down slowly, which isn’t good when you’re trying to get a transmission in or out. I’ve had it less than a year.

This looks ideal initially, and with a great price. In reality, its underbuilt, the table it is very floppy, too small, and it doesn't even come close to lifting high enough. Thats the biggest issue. If youre going to use this on a regular car lift, you need a transmission jack that goes up a MINIMUM of 12" higher than these do. If you're only going to use a couple of times, its probably worth it. If you want to use it in an actual shop, get a real jack that goes high enough.

First and foremost the hardware is cheap and cheesy. Secondly the casters are absolutely trash-order good 1k casters when you order the jack, you’ll thank me later. Table is ok’ish side to side is useless and the tilt is super sloppy,and yes they used the same cheesy hardware for the tilt and side to side adjustments. The jack itself works but the ergonomics are more suited for people in the five foot tall range. But it does work-I would hate to use it daily to R&R tranny’s especially if I’m working flat rate commission lol

It is hard to get it to go back down like it keeps getting stuck up and won't go own unless you force it to. Should be 100 bucks less for the quality

Unfortunately I've used this thing two times and the cylinder acts up, it is not tall enough I had to make an extension and I'm not a fan that there is no side to side tilt it's only front to back

Well the price is good, but you get what you pay for. The jack doesn't go high enough to work under a lift I can stand up under (I'm 5'10"), If the jack raised up another 6 inches I could work with it better. Now I have only used the jack on one car and the jack is hanging up when you try to let it down. The first stage will come down after a second but it stops when it gets to the second stage and you have to shake the transmission to get it to release and come on down (Kind of dangerous even with the chains secured) also the plate only tilts one way and the other handle just moves the plate front and back (or side to side depending on how you position the plate under the trans.)