Klantbeoordelingen voor VEVOR palletvork 1490x70x230mm vorkenbord 907kg laadvermogen vorken 149cm totale lengte met 109,2cm vorkblad heftruck heftrucktanden voorlader palletframe

Die Gabel selbst hält die 1000kg vielleicht aus aber nicht die CAT1/CAT2 Bolzen. Habe damit ca. 400kg gehoben und die Bolzen sind verbogen.

I found the forks absolutely useless and a complete waste of money!!! First, I had to file the divider down to fit it over the forks. Second, When I tightened the bolt to keep the divider at a constant width, it snapped quite easterly and Third, The forks wouldn't stay tight on the FEL bucket, it didn't matter how tight I initially tightened them. Typical CHINESE RUBBISH, I should have known better. I would be VERY hesitant to buy anything from Vevor again.

The product arrived and is what was expected. But, much to my dissapointment only half ot the required hardware, 2 of the 4 nessecary 20mm bolts, were included. When I coresponded with Vevor Customer Service, and asked to have those bolts sent, I was told that Vevor did not have them, nor could they procure them, and I was offered a partial refund. I took the refund, and eventually did find the proper 8.8 Grade bolts, but as I was required to invest my time and effort, my frustration over this purchase grew, hence the 2 of 5 star rating.

They are a little flimsy but work ok for what I need to do.

Item says delivered however it's not on my porch in Ontario. It's somewhere in BC.

It was built really well but they never put the screw rods in the package and you need those to stabilize the forks on whatever you mount them to, and they wouldn’t send me replacements

They are a pain in the A## to use, always slipping, even with a plate under the hold down area, they bent my bucket. I will be welding them permanently to a plate

Was moving rafters and some how bent one of the blocks that tighten it down with my 35 hp tractor

I was disappointed when I got these. The pads used for the mounting screws are just nuts loosely threaded on. When you go to tighten them, the nuts spin on the screw and will move up. When you loosen, the nuts fall right off. Very cheap design. If you are putting the forks on one time and leaving them, it would be okay. But if you are constantly taking them on and off, it is a big deal.

I did t rate it hi because its not strong enough for my use. If you're just going to make straight pics its fine but it twists easily and comes apart easy. I will find a stronger one. I wasted my money on this one