Klantbeoordelingen voor VEVOR palletvork 1490x70x230mm vorkenbord 907kg laadvermogen vorken 149cm totale lengte met 109,2cm vorkblad heftruck heftrucktanden voorlader palletframe

Forks are good but the bolts that clamp on the bucket bend very easy :( Maybe user error but I'm sure the were secure before I moved the logs and pallets Welds on nuts broke so maybe that was the problem and it happened on both forks at seperate times

I bought these forks because they looked like a perfect fit for my New Holland tractor. Looked perfect when unpacking however I ran into a problem. When trying to attach my lower control arms I found the holes drilled on the bracket were too close to the frame of the fork attachment. I could not put the pin in, the holes should have been an inch farther from the frame. Not sure if I should return or remove and weld on new steel brackets that are a little longer. I willl attach the picture. I the lower arm will be beside the bracket for the picture to show distance is not large enough

Kinda bulky, Used on my Backhoe loader probably over did it but bent one fork at the weld trying to lift some logs I cut up Good for light duty IMO but not 4000 lbs a Chevy weighs 3600 lbs LMAO

It work

Good product for the price and they work well. Only complaint is they do slide around your tractor bucket and don’t stay straight even when secured well.

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I bought my forks about a month ago, when I received the box it was torn up and one of the yellow plates was missing. When I put it on the tractor, one of the screws was cross treaded and extremely hard to tighten. Other that that, quality is awesome and very well made. I would buy them again.

attache sur les bras de relevage trop courte, attache des fourche trop fragile

Quality of steel forks are really good but the center likes to pop out sometimes. If they made the center a little more steady it would be pretty good product.

Get what you pay for within a couple days the paint on the forks flaked off peeled off. Tighteners are difficult to work with. If you can afford it by high-end.