Klantbeoordelingen voor VEVOR Lasdraaitafel 400 W, Laspositioneerder 500 kg, Kantelhoek -45° tot 90°, Snelheidsregeling 0,2–2 tpm, Elektrisch & Voetpedaal, voor Snij-, Slijp- & Montagewerkzaamheden

Received this positioner last week. The chuck will not hold my pipe tight enough and the pipe keeps falling out while welding. Vevor customer support responded today with “The workpiece is not holding securely because the clamping range of the modified chuck does not accommodate the specific diameter of your workpiece, which is why it comes loose and falls.” I believe this positioner would be good for sharpening pencils, but as for welding I would pass.

No ne arrivati nesun documento con merce... non ce anche fattura

Speed is too high for welding tubes 2.5" or less

Unit arrived non-operational, I gave Vevor a thorough diagnosis & pictures, and three weeks later there's still no progress towards a resolution

I got the 10kg rated positioner, that's probably an accurate estimation of it's capacity. However, it has 2 main problems. Firstly, it's almost unusable with the gear ratio provided, it spins far too fast unless you're welding pencils or something. Luckily, that's a $15 fix by purchasing a 15rpm gearmotor and throwing away the 88rpm one that comes with the unit. Secondly, the chuck is very underrated for this positioner. It's more than a $15 fix, but I had a 5" chuck from an old lathe that I was able to adapt to this, and it suits it much better. So basically, it spins too fast and the chuck is too small. But it's so inexpensive I would still buy it again if I lost this one. One more thing that would be nice is a digital readout on your rpm so you could do repeatable procedures, but not a must-have.

hyvin toimii mutta useaan käyttöön ei saa tarpeeksi hitaasti pyörimään. vaihdoin moottorin siihen hitaampaan niin toimii hyvin

Needs to be way slower. Half the speed if not more. Shouldve bought the heavier duty one fkr the slower motor. Now im scrambling to find a reducer gear box 4gn100k or higher and it's not proving easy.

Hieman liian nopea pyöritys hitaimmillaankin tälläisen harrastajahitsarin käyttöön. Kallistuksen lukitus voisi olla parempi. Kevyilla kappaleilla toki ihan toimiva

It arrived with a damaged box; it works, but it's dented. I need a replacement and a refund.

I dont think they could make the arm that holds the mig gun couldn't be made any cheaper its all pretty sloppy with little tiny wing nuts that dont hold the arm still they should just make better & charge a little more ,the motor part works fine so far the timer could be a little better & it could go a little slower the speed adjustment is all over the place.