Klantbeoordelingen voor VEVOR Lasdraaitafel 400 W, Laspositioneerder 500 kg, Kantelhoek -45° tot 90°, Snelheidsregeling 0,2–2 tpm, Elektrisch & Voetpedaal, voor Snij-, Slijp- & Montagewerkzaamheden

I got the turn table and it was great. I was concerned a little bit as there was a hole in the side of the shipping case. One of the screws that held the base to the shipping container was not installed and as such the turn-table moved around. I was not please very much with the manual that came with the unit and it could have been written better. On auto can I keep the unit running continuously, or does it time out after 11 seconds?

Boa máquina , qualidade e preço bom também dá para fazer um bom e mais potente sistema de soldadura e corte plasma

Neskutočne mi to urýchlilo zváranie. To či mi predtým trvalo 7h som mal hotové za 2h a to nehovorím o pohodlnosti.

The price was great, was well packed, plugged it in and went to work. Could use a little better ground connection but does what was needed!

This was a great buy at a very good price. I did add a larger 3 Jae chuck. It's very easy to set up and operates welll.

For the price you can’t beat this positioner. I got the largest option due to the slower turn speed and I’m happy I did because it goes plenty slow for what I need to do. Only downside is there isn’t a way to purge the pipe from below so stainless is unfortunately off the table. But for aluminum or steel pipe it’s awesome

Very handy for tig welding, speed control is great, the chuck is small but works great for small cylinders..would recommend.

Purchased one of these for a welder in our shop (who requested it) to expedite welding nuts to steel plates. I inquired regarding current rating prior to purchase and was told the ground brush was rated for 80 amps. I was concerned it may be marginal for our use but for the price figured I would give it a try. I've spot checked with our welder since who said he has used it in the 110amp range with no issues. I will admit I was originally a bit of a skeptic figuring it was going to be cheap junk and not hold up but so far it's held up quite well and saves our welder a lot of time.

Makes any kind of rotary welding a breeze. I use adjustable rollers for heavier stuff and it works even better!

Sehr gutes Preis Leistungs Verhältniss. Ordentlich verarbeiteit und keine scharfen Kanten u.s.w. Drehzahl sehr fein regelbar.