Klantbeoordelingen voor VEVOR hydraulische werkplaatspers 6 t H-frame van rood koolstofstaal, 4 hoogte-instellingen 50–230 mm, hydraulische pers met beweegbare persplaat en antisliphandgreep, voor buigen, richten en persen.

The press works well. Easy to assemble. Easy to use. One strong suggestion: Add two “sleeves” to the kit. They should be installed on the two bolts that go through the Rest that the item being pressed lays on. They should hold the two channels apart to ease movement Of the rest up or down. Without the “sleeves”. The rest is clamped in place restricting movement. The support pins should be adequate to hold any down pressure applied to the rests.

Muito bom e só em 3 utilizações ficou pago.

Ça fait le job je l'ai utilisé pour silentbloc et roulement nickel

Litt spinkel, men helt greit til mitt bruk

A bit difficult to square up. Use it to laminate various hardwoods plies for turning stock.

Item delivered 2 days before estimated delivery. Very nice little press. I used it to remove and install front wheel bearing and hub on 2003 Toyota tacoma 4x4. Worked good. If anything it'd be nice if the frame was a little bigger. For a six ton ,not bad.

Den Virker ok til prisen. Så Nu må vi se hvad den siger til hjullejer og diverde undervognsbøsninger og så videre 👍

Pour le prix et vue que je m’en sert pas si souvent je trouve que c’est une très bonne achat juste faire attention il n’y a pas de garde de protection

overall it does the job. it is not balanced, the holes for the legs leave it side ways, if you can correct that so its leveled you will be solid.

Man får det man betalar för men den gör sitt jobb. Kunde varit bättre infästning för själva hydrauliska kolven.