Klantbeoordelingen voor VEVOR Handhendelschaar, 155 mm, Plaatschaar, Guillotineschaar met massief stalen frame, Stalen plaatschaar met verlengde handgreep voor het knippen van staal, koper, wapeningsstaal en aluminium

Esto no corta patina el engranaje quisiera devolverlo por k no vale pa na

Tried to cut a 1,5 mm steel plate, but a shear pin inside broke iand it is now unusable. But it was good for cutting aluminum plates and easy to cut round shapes. Have tried to replace the shear pin with a piece of a drillbit, but the material is a bit warped and I will have to use an angle grinder to remove it, but I think it will be possible to use it again. Will only use it for Aluminium in the future since the steel is to soft for proper operation when cutting steel

I am afraid to say this is not very good quality used it first time and broke not very robust and engeeniring is of a low quality so not good

Pessimo articolo, sicuramente dal prezzo cosi contenuto l avrei dovuto capire fin da subito, tuttavia avevo necessità di una taglierina e questa era l unica disponibile in pochi giorni. E' praticamente inutilizzabile, oltre ad essere vecchia, si percepisce dallo stato di usura della vernice che sia stata prodotta qualche anno fa e conservata male in deposito. Presenta un errore tecnico che è rappresentato da uno "scalino", che rende impossibile un taglio non sbeccato. Non trovo quale altro utilizzo se ne possa fare, di certo non taglia fogli di allumino neanche di 4/10 di spessore (poco più di un foglio di carta. Sconsigliatissimo

seems to to be okay on the thinner metals, haven't given it much of a workout yet.

the shear is ok but very hard to use on flat bar

The description says it will cut steel to .08 (80 thousandths) thick, which is 14 gauge steel. I am using a lot of 16ga HOT ROLLED steel, and it will not cut it. I have had to resort to using a plasma cutter or friction blade and trimming/finishing. To see what it would cut, I cut some 20gauge aluminum sheet just fine, as well as some 20gauge hot rolled steel. Even cold-rolled steel at 18 gauge would not cut. So, since I bought this to do 16 gauge steel, its a big disappointment. But I do a lot of circuit board work and it cuts FR4 easily so I'll keep it for that. One reviewer says he uses it to cut 12Gauge steel, I dont see how.

Does not want to cut sheet metal it slips a lot

unit will not cut seems the cutter are not aligned properly. I'm requesting a refund.

after about 4 hours of fixing the shear it works good, all bearing holes were stamped out not round . i had to round holes add bearings now it works good . i call this a kit shear