Klantbeoordelingen voor VEVOR Tandwiellagertrekker, Lagertrekker, Set van 11,3 cm + 11,3 cm + 13,2 cm, voor Dana 30, 40, 60, 70 en Ford 10,25 inch

Worked so good we laughed. My buddy came over with the diff. We installed the tool, hit it with the impact, it was off in seconds. It was over so quick and was so anti climactic that we just broke out laughing. In a world where you usually need to tap things with a hammer and apply heat to get parts apart, this was a breath of fresh air.

Excellent product Worked great on my au fairmont irs m80 diff for the carrier bearings and pinion bearing

RAS commande reçue dans les temps sans problèmes .Je recommande

Well I was sure the arms were to big for my 60 hp outboard and I was correct so I reverted to the store bought tool I was using, a turnbuckle w a eyelet and a hook end. Mariner tools are not commonly available or extremely expensive so I improvise alot. But due to the sturdy size of the Vevor tool I rigged it up and hammered on it. It was being very difficult to get carrier out but it finally came out anything would collapsed bravo to another perfect Vevor designed tool.

Great product

Has pulled every carrier bearing I ever needed to pull. Borrowed to some friends they loved it too.

Had to open up the yelllow clamshell to work on a Dodge 9.25” pinion, but it still worked.

Works well. I removed the pinion bearing several times during setup of new gears on an old Chrysler 8 1/4". I did not need to remove the carrier bearings since it was all new, but it appears the tool will work.

Gör jobbet enkelt och snabbt vid lager byte på tex piniong. Säkerställer avdragning av lager utan att riskerar lagret som fort annars kan bli kostbart.

Bought for a 9” center section I am building for my 66 f100 build. Worked well and we have used on a few more carriers for wheeling rig builds. Recommend purchasing if your planning on doing differential builds.