Klantbeoordelingen voor VEVOR Dent Puller Set, 60-delig voor het verwijderen van deuken zonder spuiten, met Golden Lifter, Bridge Puller, Rubberen hamer, Lijmpistool, Hagelschade verwijderingstool op autocarrosserie

I was amazed that the glue holds as the dents are pulled, then releases easily with alcohol spray. No damage to the paint whatsoever!

È un ottimo kit per il prezzo a cui è offerto, non è un prodotto professionale, ma se si sanno usare gli strumenti in dotazione, il risultato non è male. Nel complesso sono soddisfatto dell'acquisto.

Nog niet gebruikt

Purchased Oct 6/26 to repair hail damage . After trial and error I found that waiting at least 5 minutes for the glue to dry and using plenty of glue I got the best results. Some dents were removed completely and others there was a very small dent left but not very visible .Being that this is my first attempt at hail damage repair I am quite satisfied with the results and would definitely recommend this product. Mike T

pas de problème

Have not used it yet. Looks like everything is included.

Great product worked as it should amd was easy to use. Only can give a review as I used it on small dents

Bought this for fixing dents in the tractors I am restoring, and so far it has worked well!!!

Comes with a great assortment of parts for pulling dents out. I have only used it on my daughters truck tailgate so far. Someone backed into her tailgate and dented it in pretty good. Did not want to have to do a claim even though it was not her fault happened at work and she was not in her vehicle. After work came out and tada someone was nice enough to hit her truck and leave. No cameras in the parking lot so what a scumbag. But dad to the rescue with this tool i was able to all but make the dent go away. You can see a tiny little scratch were the vehicle made contact and it scratched the paint, but the dent is virtually gone, and it was a 4 inch by about 8 inch dent. Make sure when you use the glue gun you try and go in a circular motion when putting the glue onto the plastic puller head. Also i was letting it dry for about 15 minutes to make sure the glue was nice and solid. Once you have to remove the puller from the vehicle just poor rubbing alcohol over the glue and wiggle it back and fourth slowly and just keep spraying the rubbing alcohol on the glue and it will come off. One word of advice if you are using the puller were you use the glue on the middle of 3 plastic heads and screw it inward to pull the dent out. Keep an eye on the 2 outer plastic heads so that you don't screw it in so far that they start to make a new dent as it pulls out the dent you are trying to pull out. Best way to do it is loosen up the outer screws and move it around and pull it out a little at a time. Worked great in the end.

Super Spielzeug für Bastler Kann ich weiterempfehlen einfache Bedienbarkeit Würde ich erneutem Bedarf wieder bestellen.