Klantbeoordelingen voor VEVOR 25-delige kogelgewrichttrekker, kogelgewricht-extractorset, 520 x 430 x 90 mm, universele kogelgewricht-uitpersset, koolstofstalen autogereedschapsset met koffer, kogelgewrichttrekker

Great kit! Well built with a nice storage case. Worked great for all vehicles I have used it on to include a JD Gator.

Haven't had a chance to use either one but they look well built and ready for use I've got some ball joints to put in soon

Tool kit has been great. One of the cups bent, but customer service sent out a new one under warranty. Definitely recommended.

J'ai acheté ce coffret pour changer des rotules de suspensions et ça à fait le job. En revanche la prise en main si on est pas mécano est pas forcément évident. Attention à bien forcer dans l'axe sinon ça a tendance a se déformé.

Travail très bien ça facilite le travail de beaucoup d' être bien outiller Changer ball joint du haut Sierra 2018 (ce n' est pas lister sur le feuillet) seul ceux du bas sont lister mais ça fonctionne bien quand meme.

Den funkar som det är tänkt och underlättar verkligen bytet av spindelleder. Det sparar verkligen mycket med tid och den är helt klary värd sina pengar.

Very nice set up but would like to have some more angled cylinders for uneven areas what's strong enough to pull out the ball joints on a Jeep Wrangler not were in there pretty damn tight. it would be nice if they came with two sets of threaded rods that way when you're in tight areas you could use a smaller threaded rod instead of having to take apart more of a vehicle to get the press in there.

Has worked well for me. Mostly used it for u joint removal, maybe a couple different cups would be nice but overall, i recommend it. I am a casual user so it works for me

Hat gut Funktioniert

Had to do a full front linkage replacement on a 2013 Ford F-150 XLT. Bought this to both press out and press in the lower Ball Joints. First one pressed out with a little heat, second one needed the to be started with a sledge, to overcome the rust ring, but as soon as it was flush, the next tap popped it out. Both new ball joints went in fairly easy. The only issue I had with this kit is the press adapter rings (there are 3) were almost too coarse in diameter to press my joints in, the medium one was too small, the larger one was half on the edge of the ball joint housing. After getting it to straddle that edge evenly, the press went well. It IS quite a comprehensive kit and I'll probably only use it one or twice, bought it because I wanted to make sure I had ALL the adapters I needed and I only needed 4 parts. It would also be nice if all of the plates and tubes had some identifying mark to match a part list, so you know what cars they go to. They do have a application list in the manual but it only applies to 2004 and below cars and trucks.