Klantbeoordelingen voor VEVOR 4-klauwplaat, φ200 mm, zelfcentrerende klauwplaat met 38,1 mm 8-draads inzetplaat, klembereik 4-200 mm met T-bouten, HT300 materiaal, voor hout-/metaaldraaibanken

This chuck centers excellent and furthermore the already mounted back flange has the same fitting as my Swedish built BLOMQVIST BSN600 benchtop lathe main spindle. I bought this far to large chuck as I sometimes have use for the large capacity and already have used it, see photo. I am very satisfied with this purchase.

The machining on this chuck is very impressive. I will say make sure you take it apart and clean it before using, there was a lot of cast iron dust and burrs, dont let that scare you though thats how it is with most machining tools you get from china. I intially had .004 run out on my chuck but i didnt use the d1-4 backplate i had to convert it to L00 for my clausing, ive since dialed it in to under 0.001 and am very happy with it. i did a full tear down and review on my youtube channel, check it out if your interested. https://youtu.be/CnWz48_l_3Q

I am giving this chuck only 3 stars because of the fact that it catches chips in the scroll causing it to jam up when trying to open and close the jaws. As far as accuracy it's almost always under. 004 . I can usually get it down to about. 001 with some tweaking using the three different scrolls when tightening it up. But it's a little time consuming. I would say it's acceptable, but not great. I have revised my review to 5 stars for the fact that Vevor customer service contacted me based on my original review, asked questions relevant to the problems I encountered and took appropriate action to solve the problem. Great customer service and I am very pleased.

Muss nachgearbeitet werden, aber sehr guter Rundlauf

Spoko uchwyt, wykonany precyzyjnie jedyna uwaga to trzeba go rozkręcićm umyć i nasmarować bo w środku nie ma ani grama smaru tylko pyły po obróbce. Po tygodniu takiego używania zauważyłem że zębatki na pokrętłach mają niewielkie wgniotki. Ale ogulnie ok

goede service en perfecte klauwplaat enkel uitkuisen voor gebruik(hier en daar fabricatie metaal schilfers) voor de rest zeker aan te raden

Tiene muy buena pinta y lo recibí muy rápido

I had the good timing to order this "little monster" to a really nice price. I got it some days ago and the work to turn an unused flange fitting to my Blomqvist lathe was fairly quick done. The specs for runout for a 6" is 0.08 mm and I measured 0.04 mm total runout with a 12 mm centerless ground steel shaft. I bought this chuck mainly for holding thinwalled rings and very short tubes. The entire chuck was disassembled and washed clean, sharp edges were softened. Prior to reassembly way oil was used onto all surfaces. I am impressed by the very good runout achieved and this is really high value for spent money.

very good

6 Jaw chuck did fit my lathe with camlock D1-4. It came so dirty and didn't like to move smooth. Had to take it apart, clean every part. Debur it, rework it. Grease and oil. Cut down the plastic back plate because it was touching the gears. Took me 2 hours. Now it is a good chuck with 0.05mm runout