Klantbeoordelingen voor VEVOR Wieluitlijngereedschap, 2-delige set uitlijnplaten, roestvrijstalen wieluitlijnplaat, nauwkeurige meting van de spoorhoek, incl. 2 meetlinten en conversietabel

Well built from heavier stock than I expected and longer size works good for more accurate settings. It's well worth the price

Bon produit dommage qu’il ne soit pas fourni avec des cales pour éviter de bloquer dans les étriers

Fast alles super, Top Qualität, schnelle Lieferung, einfache Handhabung nur ein kleiner verbesserungs Vorschlag, auf dem Bandmaß könnte die Skala auch in cm sein. 🤔 Bin sehr zufrieden und würde es auch wieder kaufen.

Could stand to be a bit thicker gauge, but they definitely make alignments easier. Tape measures are cheap garbage but they function for now.

I have used this alignment tool to adjust toe-in on 3 vehicles. On my Suzuki wagon 2whl drive, Hyundai sedan 2wd it worked excellent. Accurately adjusted all four wheel's toe in and the car now drives, rolls efficiently. On my 40 yr old GMC pickup rear wheel drive this tool did not accurately measure toe in due to the fact that with this type of steering mechanism the toe in varies according to how much weight is suspended by the wheels. Even if you place the jackstand near the outside of the control arm it's still out somewhat which leaves you guessing. The tape measures are very low quality, otherwise I would rate the overall quality higher. Better than no tape measures and it's good to have a matched set. The stainless steel alignment bars are good, fit on a variety of different wheel hubs. I would recommend a level for setup. Never work under a vehicle with even the slightest chance of it falling on you.

Used to do accurate alignment on my Willys jeep. Simple to use on old vehicles. All you need after replacing tie rod ends.

With a little modification this item help me adjust the wheel alignment on both my Ssangyong Korando and a little citroen c3 picasso. Modern cars may have the bumper a little low to use this but I made a small extension from wood to lower the tool. Worked perfectly. Perhaps not as accurate as lazer 4 wheel alignment but as a budget option it works well enough.

Was looking for something to use on an old air-cooled VW with a 5x205 bolt pattern and was led to believe this would fit. it does not. After widening each slot 1/4" it fit and worked fine. I'm happy with the tool after the modifications but don't think I should have had to make them as the bolt pattern was listed in my search criteria.

Dont fit my old cars from 1984 and 1990 I got 4x160 pdc - which its not fitting at So I need to modify it myself. But overall - quality seems to be good. So maybe its harsh to only give it 3 stars, because I got that pdc - but for me personally - it cant be higher than that.

I was thrilled that I could do a wheel alignment for my 1970 C-10. As per instructions the two wheel drive was elevated and adjusted accordingly to directions. Unfortunately when I lowered the truck under load I could not get the wheels aligned. I ended up adjusting by putting wheels back on and and carefully measuring tire to tire to finally get alignment within an 1/8 inch I definitely will be returning item as it did not do the intended job