Klantbeoordelingen voor VEVOR Wieluitlijner, 2-pack wieluitlijnplaten, roestvrijstalen teenhoekmeetplaat, 4 uitlijnstaven en magnetische sleuven, inclusief meetlinten en omrekentabel

Made setting the tow easy but was a fail on camber and castor on my 1969 dodge Dart. The factory wheels sit too far in so the tool interferes at the fender.

I have used this alignment tool to adjust toe-in on 3 vehicles. On my Suzuki wagon 2whl drive, Hyundai sedan 2wd it worked excellent. Accurately adjusted all four wheel's toe in and the car now drives, rolls efficiently. On my 40 yr old GMC pickup rear wheel drive this tool did not accurately measure toe in due to the fact that with this type of steering mechanism the toe in varies according to how much weight is suspended by the wheels. Even if you place the jackstand near the outside of the control arm it's still out somewhat which leaves you guessing. The tape measures are very low quality, otherwise I would rate the overall quality higher. Better than no tape measures and it's good to have a matched set. The stainless steel alignment bars are good, fit on a variety of different wheel hubs. I would recommend a level for setup. Never work under a vehicle with even the slightest chance of it falling on you.

Used to do accurate alignment on my Willys jeep. Simple to use on old vehicles. All you need after replacing tie rod ends.

With a little modification this item help me adjust the wheel alignment on both my Ssangyong Korando and a little citroen c3 picasso. Modern cars may have the bumper a little low to use this but I made a small extension from wood to lower the tool. Worked perfectly. Perhaps not as accurate as lazer 4 wheel alignment but as a budget option it works well enough.

Was looking for something to use on an old air-cooled VW with a 5x205 bolt pattern and was led to believe this would fit. it does not. After widening each slot 1/4" it fit and worked fine. I'm happy with the tool after the modifications but don't think I should have had to make them as the bolt pattern was listed in my search criteria.

C'est pour faire de l'approximation, mais un para à la ficelle est plus précis. Necessite un sol très plat. Précision 1°

They work if you have a good smooth shop floor

Dont fit my old cars from 1984 and 1990 I got 4x160 pdc - which its not fitting at So I need to modify it myself. But overall - quality seems to be good. So maybe its harsh to only give it 3 stars, because I got that pdc - but for me personally - it cant be higher than that.

Didn't work well for me. Maybe it was the lack of instructions.

Hyvä idea mutta ei ole kovin tarkka, mittanauhat liian ohutta niin jäävät roikkumaan. Tämän säädön jälkeen käytin oikeassa säädössä, niin melkein 2 astetta oli haritusta vaikka tämän mukaan piti olla 0. Jatkoraudat ei mahdu toisinpäin kun ottaa pyörännapaan kiinni. Sanoisin että yhtä tarkan tuloksen saat pelkällä mittanauhalla, tässä menee kyllä rahat hukkaan.