Klantbeoordelingen voor VEVOR Werkbank, 680 kg, Werktafel met eikenhouten werkblad van 122x60 cm, in hoogte verstelbaar van 67-102 cm, Werkbank voor garage, werkplaats, thuis, kantoor en commercieel gebruik

Table top damage with large divers upon unboxing

This company tried negotiating with me to keep a full length crack in the benchtop. $60. I refused. I wanna brand new uncracked top. They told me they could not help me. So, I clawed the money back through PayPal. Then, they offered me $100. I refused. They saw the money clawed back and FINALLY sent a new unit. Typical Chinese B.S. BUYER BEWARE!

This unit may have the same trouble I had in my review of the 60” work table… have not had a problem yet but have a feeling it is cominh and will fix the same way with a 2x frame for the legs..

De gebruiker heeft geen schriftelijke opmerkingen achtergelaten.

Ist ok aber mehr auch nicht. Der Tisch sieht gegenüber dem ohne Steckdosen sehr anders aus. Die Steckdosen sind nicht zu gebrauchen. Diese machen einen absolut minderwertigen Eindruck. Zudem sind diese sehr schlecht sichtbar mit Max 10A gekennzeichnet. Das spricht schon dafür, dass die wahrscheinlich gefährlich sind. Ich werde diese mal öffnen und die Kabelstärken messen. Insgesamt für diesen Tisch - keine Empfehlung….

Table arrived with a cracked top, Vevor replaced it, but replacement was cracked even worse

This workbench leaves a lot to be desired as is very wobbly at highest setting with casters locked and drawer brackets didn't line up and drawer kept falling out. When I tried to pull brackets into to align with drawer, they broke off due to the small screws holding them in place. Should've went with the work pro that I planned. Legs need more bracing to prevent wobbling at highest setting.

On opening the package one part of the table top was cracked. This is the 3rd time I am buying from vevor and the item came damaged.

So far I’m 2 for 2 on messed up items. First was the gun safe that was missing screws to finish putting it together. Now I had to make custom modifications to the work branch. The front nuts and bolts on both guide rails, that were reassembled from the factory, clashed with the legs of the table. The instructions were vague so I figured, maybe it’s supposed to taper. After I build the drawer and tried to slide it in, I realized it was wrong. I took it back apart and used a grinder to bevel the corners so that the nuts from the guide rails can allow the guild rails to sit flush. I would say you get what you pay for but these weren’t that cheap… Know I know, with every purchase, so modifications are required.

Arrived with the work top smashed all to hell, revealing that what looks like butcher block is actually just veneer, if that matters to you) and then customer service gave me the runaround for more than a week, by which time I had purchased another bench elsewhere. They can keep my money - it's the last they'll get from me.