Klantbeoordelingen voor VEVOR Vervangende messenset voor snijmachine model 90, 7 mm roestvrij staal, vervangende messen voor professionele vleessnijmachines, kamvormige messenset geschikt voor vlees zonder bot en zachte groenten.

Très bien qualité Mais la finition un peu brut

I cannot ask for more the best

Works well

Great jerky cutting head. I've had another one for several years. Bought this one for a spare. The other one sliced 40 pounds of meat in 1 minute and 52 seconds

The original 3.5mm blade pack that came with the meat slicer was basically junk. This replacement model was much better. The spacers between the circular blades on the original were some kind of plastic or nylon. They came loose and the blades would stop even though the motor would still run. The replacement blade 5mm pack seems to use metal spacers so probably much more clamping force between blades. No problem with this one so far. I have made a jig and tried tightening the nuts on the old blade pack.. Don’t know if it worked yet I still need to try it out.

Seems to work well. I had issues with the blades stopping while running. It turns out the blades are held in there just by compression, nothing physically connected to the shaft turning the blades. To fix this issue you need to tighten the nut on the assembly. This can be complicated by the opposite side is round with a notch. I am making a custom tool to hold the round side, but you can set it up with a flathead screwdriver. Just be very careful, the blades are extremely shart. I also wish there was a storage box for these from factory. I ended up 3D printing a custom storage box for these.

i dont really know how to rate this yet ,since there are no instruction how to remove the older one and replace it, but i can rate costumer support A big Old ZERO (0) trying to get thru to them for over a week , i should send it back and try another company

Does not cut properly