Klantbeoordelingen voor VEVOR Bandenstraalmachine, 2,1 gal/8 l luchtbandenstraalmachine, 120 psi handbediende straalmachine, verbeterde draagbare bandenpomp, 85-116 psi werkdruk voor trekkers, vrachtwagens, ATV's

Good value for the money

My air chuck did not fit the one provided so I switched that out and air compressor only pumps it up to 80psi otherwise excellent quality

Super outils de bonne qualité, correspond parfaitement au photos et descriptif. Je recommande fortement cette appareil

Tank works well, has a plastic tip for the air to funnel into tire that could be better if it was metal for my application.

Works fine just one flaw as it has a plastic discharge to the tire bead. Otherwise works fine. It would have been better if the discharge spout was steel instead of plastic.

I expected better quality for a shop tool, plastic air horn doesn't work but I will adapt something better

Useful but didn't work well for long. Plug that holds the air became to fail after a few uses and would open by itself when filling.

Works great, but I do disagree with the placement of the pressure gauge. To look at it you haft to put your face directly over the discharge nozzle. If your checking pressure at the gauge and accidentally discharge the unit you're more then likely going to mess up more then just your hair.

Super dangerous. It is leaking bad around where the plastic end meets the orange metal tank. I'm afraid it's going to blow off and really hurt someone. I've contacted vevor several times and they want pictures of the air leak. I've sent pictures in but how do I show air leaking in the picture???? They just told me to quit using it. Wow that's real safe and reassuring. They still haven't said anything about a replacement. It worked good when I used it, but I feel like it could blow apart any minute now. Vevor needs to step up and do something.

Otherwise good quality item, but handle sis not thread in almost at all. There is a soldering bead seated right inside the threads. Customer service told be to get it off, but it does not chip off. I have to borrow a small cutting disc tool to clean the thread. It would be nice if this job was done already in the (nonexistent) quality control.