Klantbeoordelingen voor VEVOR TIG-lasser, 6-in-1 aluminiumlasser (groot LED-display) - AC TIG/DC TIG/AC puls TIG/DC puls TIG/Spot TIG/MMA (staaf), elektrische lasser met IGBT-omvormer

Got the 205A 2 in 1 welder. They claim it'll run 6010. It won't I've been trying to return it. They are giving me automated suggestions that are incorrect and don't work. Like running 6010 DCEN. 6010 is a DCEP rod. Don't buy.

Seemed ok at first, looked ok at first, found that gas was not being released through the torch head, found the torch head gas line plugged up with valcanised rubber, once cleared out the primary function of Tig welding seemed ok, post flow doesn't seem to work, and the up and down slope doesn't seem to work, I compared settings to another known good Tig welder and got completely different results, so in short, does it work, yes, but not well, save your money, buy a better machine

Tried this out today and on 110 volts it’s very inconsistent welds about 1/4” then stops. Tried it on 220 volts and it will run just over an inch of weld and just stops. I have a ticket in for a refund even bought the insurance and they want video’s little hard to do by yourself.

Problem med att tända pinnen, när man väl lyckas tända pinnen så dör den precis som att amperen droppar för lågt. Produkten fungerar helt enkelt inte.

Received and after a few weeks I finally got some Argon to try it out. Unfortunately it did not work. Contacted support and they tried but could not find a solution so was partially refunded and will toss the machine out and try another brand.

The welder does not work. Something is wrong internally. Will only output 10 amps. Hopefully I can get my money back the welder does nothing.

It didn’t work and doesn’t seem to be able to get a replacement or refund. I have sent several emails and answered all questions. Why can’t we get a phone number to call. I’m very disappointed! sammyharrell1957@icloud.com

The machine looked ok. But as soon as it ignites ignites the rods it droppes in amperage an stops. Ot possible to use. Maybe a bad unit, I got the money back.

It does not arc in any of the TIG modes. No voltage on the torch at all. Checked the continuity -- both the torch and the ground are properly connected to the machine. Contacted the customer service. Their last message was "Please be patient and we will get back to you as soon as possible.". Would not buy any high tech electronic equipment from Vevor ever again.

Skrot, den fungerade tills jag skulle använda den! Den ville inte tända pinnen, tog upp svetsen och kollade så att kablar satt fast. När jag sen ställde ner den så blixtrade i svetsen och säkringen i garaget gick sönder, bytte den men svetsen är död! Skrot!