Klantbeoordelingen voor VEVOR Draadsnijmachinetap 116-delig, kerngatboor-draadsnijset voor lagerstaal, inclusief 51 x tappen, 51 x snijmessensets metrisch/imperiaal

I received the tap and die set within the promised delivery timeframe and it arrived complete and undamaged. That’s where the good part stops. I had to use the m10 tap to cut a thread into a piece of steel. I drill an 8.5mm hole as required for an M10 tap and I used the handle that you secure the tap into. Before I had finished the tapping process the handle snapped. I was only tapping a thread into a 5mm pice of aluminium. I have had to go out and purchase a new handle to be able to continue using the taps. I was really disappointed as I was optometrist that this was going to be a really good set. I’m fortunately this was not the case.

Ei leikkaa vaan enemmän valssaa kierteet. Liekö vain maanantaisarja minkä sain mutta surkea on. Olen hionut osan tappeja oikeaan kulmaan ne leikaavat. Jos olisi ollut leikkaava niin hinta laatusuhde olisi loistava. Mutta nyt olen todella pettynyt.

Don’t buy it. The threads are bad/missing on some taps.

la qualité n’est malheureusement pas au rdv pour rénover des pas déjà existants ça fait le job

Good for thread chasing but not good for thread creation / cutting. Nevertheless, good price for what they are

Comparing these to an SCA set I found the quality of the tools felt a bit lower, not a huge difference. You can tell by the size markings on individual taps and dies that they come from a range of factories which doesn't inspire confidence for quality control. The box looked good, but unfortunately it arrived damaged. Some of the pieces came loose during shipping and caused a couple of sections on the inside of the case to get cracked. Overall, not bad for the price, but they should secure the pieces better for shipping.

Always using a tap or die. Bought because it was cheap. On opening it for the first time pieces fall right out and don't stay put. Only used once on a 1/4 20. No drill bit guide included. Good if your into cheap

I gave my ratings on this set based on receiving and viewing this set, I haven't physically used it yet, though if and when I do, I hope I can change my opinion.

Half the taps and dies Don't work due to the machining of them being very poor, m10x1.5 die doesn't even fit a m10x1.5 thread and noticed a bunch of them are juat poorly machined and don't work

A good range set for the money, if your a occasional user. The worst thing about it is the cheap plastic case. It doesn't hold the dies nor a good deal of the taps, so closing and opening is fraught with pieces flying all over the place. The tool handles are also cheap and loose their grip easily on the taps. Address those 2 shortcomings and it would score better