Klantbeoordelingen voor VEVOR Draadsnijmachinetap 116-delig, kerngatboor-draadsnijset voor lagerstaal, inclusief 51 x tappen, 51 x snijmessensets metrisch/imperiaal

Reçu rapidement bien préparer avant utilisation sinon risque de casse pour le prix je ne suis pas déçu c'est très bien le boulot

So viele Klingen, dass selbst Gott nicht mehr weiß, was er damit anfangen soll. Drei Viertel davon werde ich nie benutzen. 😳 Über die Qualität kann ich noch nichts sagen, die Zeit wird es zeigen.

Nice to be able to swap between metric and imperial sizes. The taps could be with being harder.

Ist keine Profiqualität! Für Heimwerker geeignet!

Goede prijs/kwaliteit verhouding

muy buena calidad y muy buen precio

Great set, has a vast range of sizes and easy to transport. Seems very durable

Good value comprehensive set of metric taps and dies. I haven't checked them all yet, and I have heard some of the pieces aren't the best quality, but I can't confirm this comment.

I bought this set to obtain some of the fine metric sizes, and to double up on some common metric sizes. The steel is a chrome moly type tools steel (NOT HSS) and done in typical chinese quality for the price range. I found 6 of the taps, and 4 of the dies were unusable due to malformed thread, or manufacturing defects (thread not square to axis, burrs in machining hardened in place, cutting edges not formed properly) Most of the smaller size taps (say 5mm or less) were not a sharp as a P&N/ SUtton HSS tap, but also considerably cheaper - so resharpen, or use with care. Sizes above 5mm were generally OK and those bigger than 9mm were comparable to the older kincrome sets. Tap wrenches, die stocks appear to be steel under the paint, so should be adequate. I would reccomend for 5mm and up in non ferrous metal work, but go gentle in steel or smaller sizes. For a one off unusual size it may be price effective, but if tapping a lot of 6,8,10,12mm holes, it would be worth upgrading the taps to HSS based ones. NOTE - After sales service - Vevor obvioulsy don't really understand how these tools are used, but their sales support people really tried to sort this out, and did try to substitute the faulty taps/ dies, but found their floor stock had similar issues. They escalated to their supplier, and compensated me for the unusuable components

The cases seem to me not to fit the tap and die were scattered all over when you open the lid. It seems to me to work just fine.