Klantbeoordelingen voor VEVOR Draadsnijmachinetap 116-delig, kerngatboor-draadsnijset voor lagerstaal, inclusief 51 x tappen, 51 x snijmessensets metrisch/imperiaal

Die Lieferung erfolgte prompt. Ich wollte mit dem Schneideisen M7x1.0 ein Feingewinde nachschneiden. Letzlich ist das Gewinde zerstört, weil der Einsatz weder maßhaltig noch scharf war. Zum Glück war das Werkstück lang genug, sodass ich den zerstörten Teil abtrennen konnte und mit einem neuen, wertigeren Tool (nicht von VEVOR!!!) das Gewinde noch retten konnte. Wer billig kauft, kauft zweimal!!! Ich rate von diesem Artikel ganz klar ab.

I am very disappointed in the lack of quality in this tap and die set because they are not sharp enough to actually cut threads and don’t produce any shavings . The set I recieved a few weeks ago appears to have missed the hardening and sharpening process or is representative of all of them. I was happy enough with the magnetic drill I first bought from Vevor, the 4 jaw lathe chuck came minus the spindle mounting backing plate and cost me hours of work and time buying a steel billet and machining to make one.due to my mixed experience I find it very difficult to recommend Vevor products unless endorsed by true professional tradesmen.

The threading taps are not ground deeply enough. And the threading dies aren't ground correctly. I tried cutting into brass, but it didn't work.

Coffret reçu avant l’heure complet, mais par contre on voit qu’il a déjà été utilisé, il y a certain tarot où l’on voit qu’ils ont été servis, donc certainement une personne qui a commandé qui s’en est servi qui a vu que ça n’allait pas et qui a renvoyé. À voir dans le temps

1/2 13 die thinner than rest. Also size not marked on it. Case squished taps falling out.

la qualité n’est malheureusement pas au rdv pour rénover des pas déjà existants ça fait le job

Good for thread chasing but not good for thread creation / cutting. Nevertheless, good price for what they are

Comparing these to an SCA set I found the quality of the tools felt a bit lower, not a huge difference. You can tell by the size markings on individual taps and dies that they come from a range of factories which doesn't inspire confidence for quality control. The box looked good, but unfortunately it arrived damaged. Some of the pieces came loose during shipping and caused a couple of sections on the inside of the case to get cracked. Overall, not bad for the price, but they should secure the pieces better for shipping.

Always using a tap or die. Bought because it was cheap. On opening it for the first time pieces fall right out and don't stay put. Only used once on a 1/4 20. No drill bit guide included. Good if your into cheap

I gave my ratings on this set based on receiving and viewing this set, I haven't physically used it yet, though if and when I do, I hope I can change my opinion.