Klantbeoordelingen voor VEVOR Schuifdeursysteem voor vouwdeuren, schuifdeurbeslag 1016 mm rail, geschikt voor twee kast-, voorraad- en wasruimtedeuren van 45,7 cm (niet inbegrepen)

quality looks good, not yet installed

Franchement je suis surpris par la qualité du matériel très bien et pose facile

Track was in 3 pieces. A little disappointed in that. Working well

parfait

quality looks good, not yet installed

Well packaged, looks good, yet to install

Great product especially for the price. Shortcomings I found were: the rail needed included adhesive foam placed between the bracket and the rail in order to keep it from being loose; the stopper for the fixed roller is very difficult to tighten because it needs to be tightened from the backside. If the large set screw in the front and the short set screws that requires an Allen wrench to tighten were reversed the product would be close to perfect.

This is a very sturdy kit. The doors slide beautifully. It took much longer to install that I had anticipated and definitely needed a second pair of hands. I gave this product 4 stars because the directions were confusing and we had to convert from centimeters to inches; not to mention there is a bit of algebra involved for figuring out how to place the part that is attached to the floor. The hardware bags were not labeled so that took extra time as well. Overall, I am happy with the final results.

Nice product but the alignment of the supplied bars is not great

Will not purchase from Vevor again, Technical Support is useless and not helpful. Use dimensions in install manual as reference only. Fixed roller was missing a long set screw, resulting in a trip to the hardware store to purchase a #10-32 1 inch bolt to secure fixed roller to the track rail. Did not use the design of the bottom pivot plate due to no adjustment with the door after securing the plate to the floor. Instead used the jamb bracket, (the design has adjustment), and bottom pivot hardware that was purchased with the bifold door, and the jamb bracket only required 1 screw to secure to the floor instead of 4 screws on the bottom pivot plate. The design of the track needs to be one piece. No matter how level and even the track connection strap, the adjustable roller still makes noise as it rolls over the connector straps. Quality control and Design at the manufacturer needs improvement. I had the same issue with the missing long set screw on the fixed roller in all 3 purchased hardware kits.