Klantbeoordelingen voor VEVOR Professional Kernboormachine Magneetboormachine Magneetkracht 12500 N, 850 tpm 1450 W Magneetboormachine 40 mm Max. Boordiameter, Magnetisch kernboorsysteem voor scheepsbouw, bruggenbouw, etc. Oranje

Maschine ist beschädigt bei mir angekommen , Kabelverschraubung ist abgebrochen, Einzelteile sind lieblos mit im Beutel der Maschine untergebracht Bohrfutter und Fräser.

It's broken.

The fitting drill vs spindle was so tight that it is really hard to mount the drill's. Furthermore the chuck adapter didn't even fit. -Comment - We have confirmed that each spindle is tested before leaving the factory, and only those within the standard range are shipped. If you cannot provide a video of the spindle measurement, we cannot make a judgment at this time. Please try using sandpaper to mark the inside of the spindle to enlarge the inner bore. -Hey, the manufacturer should have fine polished the inside. I think i have to sandpaper down the chuck adapter to make it even go in, phew. Not satisfied at all.

The treds of one handal hole where not tap right!. Had too re tap it to get handal to fit right,chine Quality at its best.but it's still cheap.

For the money it's a great magnetic drill, sticks harder than i'd expected it too. More height would be usefull, once you put the chuck in it you don't have a lot of height adjustment left. But the worst part for me was finding out the On/Off switch in not an NVR switch. So I plugged it in once I got it out of the box and it ran at full power. Very unusual for a power tool like this not to have a switch that returns to off when power is disconnected, so be careful

Drills chuck keeps falling out. Also the handles keep vibrating loose and falling out and same on lubricant bottle holder. I have used this about ten times and had an issue at least every other time. The drill chuck falling out is biggest issue.

Assez dangereux, le perçage peut facilement enfoncer la base métallique, même verticalement vers le bas ; à éviter. De plus, la vitesse de perçage est inadaptée au diamètre du foret.

Drill works well but cutting fluid leaks from the fan motor. So when it’s running it sprays cutting fluid all over

Wenn man normal bohrt ist das Gerät durchaus OK. Aber bei größeren Kronenbohrern versucht das Gerät die Drehzahl nachzujustieren, was aber nicht gelingt ... dann dreht er entweder zu schnell oder zu langsam und kann sich nicht einjustieren.

Ce modèle ne possède pas de variateur de vitesse, ce qui peut être gênant pour le perçage de gros diamètre. La présentation des modèles pourrait être plus claire, en mettant par exemple dans la description le tableau figurant dans la notice reçue avec la perceuse qui donne les caractéristiques des 4 modèles possibles. Cela permettrait de commander en toute connaissance de cause