Klantbeoordelingen voor VEVOR Plasmasnijder, 65A, Pilot Arc Plasmasnijmachine zonder hoge frequentie - met 2T/4T-functie en instelbare PT-tijd, digitaal display, IGBT-omvormer voor thuisreparaties en werkplaatsen

premiere utilisation et la torche crache des flammes par la gachette ,je viens de poser reclammation on verra bien , pour le moment c'est 1 etoile et zero si je pouvais ,suis degouté

Ha funzionato bene per le prime ore, poi ha iniziato a interrompersi a metà taglio. Si è arrivati ​​al punto in cui era difficile mantenere stabile l'arco plasma... Ho comunque finito il lavoro, ma consiglio una marca più costosa, come Telwin, se si deve tagliare molto acciaio. Quando ho finito di tagliare la vecchia caldaia a gasolio, non riusciva più a eseguire tagli lunghi più di un centimetro prima di interrompersi, anche dopo aver sostituito gli ugelli della torcia.

It's no use

Yesterday, I lost my patience with this tool; I’ve been trying to get it to work ever since I bought it. I thought the issue might be the three-phase electrical panel, so I replaced it—still nothing. I thought it might be the torch, so I bought another one. I thought it might be the cold weather and high humidity, so I even bought 3-stage NPT filters—but it still doesn't work. I tried adjusting the pressure, but it won't strike an arc at all. Occasionally, when it makes contact with the metal plate (to which the ground clamp is attached), it produces a spark and starts up. I wouldn't recommend this tool to anyone; it’s a total failure—I haven't been able to use it for anything.

I dont like it he wont cut more than 5 sec without stoping

désolé , mais ne fonctionne pas , arc d'allumage et rien après

Well it was supposedly delivered to me today but it wasn't. I have not received it. I've contacted vevor through their channels of contacting consumer services but have yet to hear back from anyone!

Bonjour . Malheureusement l'appareil ne fonctionne pas bien . Des la mise en route il s 'allume et en suite s'éteint tout seul plusieurs fois avant de pouvoir commencer a découper.

Showed up to the wrong place then did not work would like a replacement

Would not recommend buying will not cut good like the description says it wont cut thin metal it looks like a bad weld when trying to use it