Klantbeoordelingen voor VEVOR plasmasnijder, 65 A contactloze pilootboogplasmasnijder, digitaal display, IGBT-inverter met 2T/4T-functie en instelbare PA/PT-tijd voor thuisreparaties en werkplaatsen.

Unbelievable price! Fast delivery. Worked great for the first time, second use it Worked for a while, then stoped arcing. I contacted customer support and they helped me find a fix the problem. Back to working! Makes amazing cuts on 3/8" and thinner plate, will cut 1/2" ok. Very lightweight, easy to transport. The only problem I found is that the troubleshooting guide in the manual for this plasma cutterer is for a welding machine. Overall it's a great deal and a nice tool.

Burns tips easy, quite hard to make cuts with right speed and distance so that the tips don't burn and get ruined. Takes lots of practice to figure out how to get the guts look clean and good. Really hard to find information about the air pressure and compressor requirements. Plastic air hoses are really hard to get sealed. ground wire clips is cheap, flimsy and the wire will break loose.

Works great.

Good and easy to use

The clear hoses used inside for the air pressure sensor are cheap and leaked from the get go, I replaced it with softer rubber vacuum line and that took care of problems,after that problem was taken care of it has worked very well ,setup is easy and it cuts very nice and I'm very happy with it for the price hopefully it lasts!

Suite à quelques utilisations je suis arrivé au moment de remplacer les consommables et malheureusement lorsque je les remplace par les consommables fournis le poste ne fonctionne plus j'en ai donc commandé sur un autre site et idem je ne sais pas où avoir des consommables identiques à l'origine monter sur la torche.

I've not used this tool yet for any major applications. But over all assembly was easy.

Received this unit today, set it up and tested it. Instructions beyond labeling of components are non existent. Troubleshooting is for a welder! After a couple of hours of screwing around, I found that 4 of the 5 tips I was shipped were defective and produced only a very weak spark. Luckily one tip worked so I could verify that the unit was operable. The electrodes also look very cheap, so I would recommend shopping for some higher quality consumables right away, and you'll have to Google the settings for air pressure, 2T vs 4T operation, current settings etc. The unit seems ok, but it's frustrating trying to troubleshoot multiple faulty components on a new unfamiliar item. Picture of my faulty parts below for reference.

Przecinarka robi co ma robić, nie ma się do czego przyczepić- jedynie dwie rzeczy są denerwujące : czas chęcia to tylko 6 sekund - strasznie irytujące, oraz jeszcze większy minus- nie pracuje na przedłużaczu 2 żyłowym musi mieć 3 żyły.

It does fine with small cuts but if youre trying to make long cuts it tends to overheat and shut off. Ended up buying an Arc Captain Cut65MP and am so happy I did.