Klantbeoordelingen voor VEVOR Plasmasnijder, 60A plasmasnijmachine, IGBT inverter snijmachine met digitaal display, 2T/4T-functie en instelbare PA/PT-tijd voor industrieel gebruik (400V 3-fase)

The clear hoses used inside for the air pressure sensor are cheap and leaked from the get go, I replaced it with softer rubber vacuum line and that took care of problems,after that problem was taken care of it has worked very well ,setup is easy and it cuts very nice and I'm very happy with it for the price hopefully it lasts!

I've not used this tool yet for any major applications. But over all assembly was easy.

Received this unit today, set it up and tested it. Instructions beyond labeling of components are non existent. Troubleshooting is for a welder! After a couple of hours of screwing around, I found that 4 of the 5 tips I was shipped were defective and produced only a very weak spark. Luckily one tip worked so I could verify that the unit was operable. The electrodes also look very cheap, so I would recommend shopping for some higher quality consumables right away, and you'll have to Google the settings for air pressure, 2T vs 4T operation, current settings etc. The unit seems ok, but it's frustrating trying to troubleshoot multiple faulty components on a new unfamiliar item. Picture of my faulty parts below for reference.

Suite à quelques utilisations je suis arrivé au moment de remplacer les consommables et malheureusement lorsque je les remplace par les consommables fournis le poste ne fonctionne plus j'en ai donc commandé sur un autre site et idem je ne sais pas où avoir des consommables identiques à l'origine monter sur la torche.

Learning my setting had a small rust spot on top paint came off because of the rust

Przecinarka robi co ma robić, nie ma się do czego przyczepić- jedynie dwie rzeczy są denerwujące : czas chęcia to tylko 6 sekund - strasznie irytujące, oraz jeszcze większy minus- nie pracuje na przedłużaczu 2 żyłowym musi mieć 3 żyły.

It does fine with small cuts but if youre trying to make long cuts it tends to overheat and shut off. Ended up buying an Arc Captain Cut65MP and am so happy I did.

Having problems getting this thing to work properly. No number to call for support. Online bots were no help

so far 1/5. out of box failed - Pilot arc does not function, looks like high frequency cct is likely the issue. - 4T also does not work.. 4T functions the same as 2T.

jeg modtaget den i dag og åbent kassen og fandt jeg ud af at der er noget af nogen af delene er brugt 😡 Det er bare ikke i orden at jeg ikke længer kan stole på jer!!