Klantbeoordelingen voor VEVOR plasmasnijder, 50A plasmasnijmachine, digitaal display, IGBT-inverter snijmachine met 2T/4T-functie en instelbare PA/PT-tijd, ideaal voor thuisreparaties en werkplaatsen.

Ha funzionato bene per le prime ore, poi ha iniziato a interrompersi a metà taglio. Si è arrivati ​​al punto in cui era difficile mantenere stabile l'arco plasma... Ho comunque finito il lavoro, ma consiglio una marca più costosa, come Telwin, se si deve tagliare molto acciaio. Quando ho finito di tagliare la vecchia caldaia a gasolio, non riusciva più a eseguire tagli lunghi più di un centimetro prima di interrompersi, anche dopo aver sostituito gli ugelli della torcia.

Received this unit today, set it up and tested it. Instructions beyond labeling of components are non existent. Troubleshooting is for a welder! After a couple of hours of screwing around, I found that 4 of the 5 tips I was shipped were defective and produced only a very weak spark. Luckily one tip worked so I could verify that the unit was operable. The electrodes also look very cheap, so I would recommend shopping for some higher quality consumables right away, and you'll have to Google the settings for air pressure, 2T vs 4T operation, current settings etc. The unit seems ok, but it's frustrating trying to troubleshoot multiple faulty components on a new unfamiliar item. Picture of my faulty parts below for reference.

Leider liefert das System nur 33 A Ausgangsleistung und keine 65 A - wie versprochen Nach einigem Hin und Herr mit der Hotline wurde der Kaufpreis dann aber rückerstattet

For cutting thin players it is good, but I needed plazma for 2mm metal cutting so it barely makes it.

Bonjour . Malheureusement l'appareil ne fonctionne pas bien . Des la mise en route il s 'allume et en suite s'éteint tout seul plusieurs fois avant de pouvoir commencer a découper.

premiere utilisation et la torche crache des flammes par la gachette ,je viens de poser reclammation on verra bien , pour le moment c'est 1 etoile et zero si je pouvais ,suis degouté

Well it was supposedly delivered to me today but it wasn't. I have not received it. I've contacted vevor through their channels of contacting consumer services but have yet to hear back from anyone!

Showed up to the wrong place then did not work would like a replacement

Would not recommend buying will not cut good like the description says it wont cut thin metal it looks like a bad weld when trying to use it

WORKED FOR 170 FEET QUIT, CAN'T GET THEM TO WARRANTY IT.