Klantbeoordelingen voor VEVOR paneelheffer tot max. 68 kg, hoogte 3353 mm, gipsplaatheffer met verstelbare telescopische arm, gipsplaatheffer, paneelheffer, hijsapparatuur, gereedschap, voor plafond- en wandmontage (rood)

Works great. Used on house remodeling and home addition. Used to hand drywall and OSB. One person operation

Simply easy and very handy. I struggled for weeks trying to hang sheets by hand and cut it out but ended up breaking more sheets then I successfully hung.

I've had an 8' lift that I've used for 15 years, but bought this lift to reach a 13' cathedral ceiling. The price was the reason for the purchase. The quality is as expected - a bit sketchy, especially when lifting a 110 lb / 12' sheet of drywall 14' into the air. The pin that is to secure the tripod base would not securely hold the base (the legs kept folding in!), so I had to drill into the catch assembly and insert a bolt. I got exactly what I expected for the price and I do not regret the spend. This unit did the job...

De platenlift werk goed en ben tevreden voor de prijs is hij goed. Het doet wat het moet doen en heb er mijn klus mee geklaard.

It works fine for 8’ drywall with the extensions off but the extensions for holding 12’ drywall are not built correctly so the center of the panel won’t press to the ceiling, only the ends touch.

fairly sturdy machine, problem is the lowest setting is shoulder height for a 6 foot tall person. Almost impossible to load the sheet rock that high by yourself without getting injured. Very inconvenient. Still requires two people to load the lift.

Broke on first use

think of this as disposable. one time use. Quality is ok but its hard to use. The cable used to wind up the lift does not wind right. Its not aligned with the wheel used to wind it. So you have to pull it to the side to get it to wind

I would like to return it Useless bad design small wheels can't hold the Sheetrock

The lift I purchased failed almost immediately. The lift is three major pieces. The panel support drops into the post. At the point the welds completely failed on the 8th panel leaving the entire panel support free to wobble over 40 degrees as measure with a level. Vevor supports solution was to refund $48 and for me to find a local welder to fix the connection point. When I stated this was not an appropriate solution they closed my ticket with no resolution.