Klantbeoordelingen voor VEVOR stoelveringset met stoelrail, luchtgeveerde stoelvering met stofkap, 150 mm van voor naar achter verstelbaar, tractorstoelveringset voor zero-turn grasmaaiers, vorkheftrucks

Universeel onderdeel voor heftruck, verreiker, tractor , of wat dan ook. Bestelbaar met en zonder geleiders. Er zijn gaten voor meerdere types. Vering is oké . Dit onderdeel is erg zwaar, maar degelijk.

Used this on my JD 530 Zero Turn. Installation was fairly simple. The holes didn't line up completely so i had to do some remanufacturing of the to make it fit. Took about a hour to install.

It was well made but it couldn't be used in my application.

Overall the product is pretty much what you see is what you get but don't be fooled by the description that it is suitable for a zero turn mower. Think through seriously how it might change the handling of your equipment, especially, on hilly terrain. It raises the seat height so much that you can be thrown out of the seat going over a bump or when leaning or turning on a hillside. Otherwise, it might be fine and does provide cushioning. Also my zero turn has a steering wheel and it nearly brings my knees to the height of my steering wheel changing the ergonomics. Finally, the instructions on how to mount it are non-existent, so you are left your own ingenuity to figure it out and may have to try several different ways so that it doesn't interfere with your seat adjustment lever. Your application may make it difficult mount.

dit is geen luchtgeveerde onderstel

not an air ride seat. uses a spring. wrong description.

I finally gave up trying to figure out why the slider was either binding or not being released by the lever. Not for a DIY customer. Lots of drilling for a mower install. Box says forklift and it appears that is what this product is designed for.

Ordered this for my 2021 Toro Titan. I am a very experienced mechanic, worked aircraft engines, automotive and even cranes. This kit is heavy, seems well made overall. The issue is installing it! Not a single hole on the seat plate lined up to do any good. I had to take the actual seat apart more than once, had to drill the seat plate, and the main suspension section to make it work. Once installed a few hours later, it does work well, but it will raise you up around 4-6 inches! If it was easier to install i would give it 5 st a rs. If you don't have good drill bits, step bit ect, don't buy this. Take your time and check and recheck your placement of the plates.

Holes for seat plate, JD935 zero turn.did not line up had to jig saw 2.Needed 1.5 inch spacers to attach to seat plate to allow seat slide adjuster to work and could not tighten bolts to seat adjuster or it would not slide freely. OTHERWISE Great product for the money and works well !

was not as tight as I would hope, has lots of side to side play easily mounted and slide features work how they should price and shipping is good