Klantbeoordelingen voor VEVOR stoelveringset met stoelrail, luchtgeveerde stoelvering voor zero-turn grasmaaiers, 150 mm van voor naar achter verstelbaar, tractorstoelveringset voor heftruck, bulldozer

Works pretty good

buy it for my john deere z655 Zero-turn mowers a little planning. I made it work on my mower and it works good.

I enjoy the extra comfort this allows me. That being said it was a challenge getting it to fit on a Craftsman YTS4000. I was a truck mechanic for 25 years so I have plenty of experience and it still took me quite a while to get this installed. You will need to do some hole drilling and MacGyvering . If I had to do it again I could cut it to a 1/4 of the time. And I would do it again. The difference is very noticeable and the price is the best I found.

Good product! Was able to adapt the suspension seat to my Troy-built Z54 and works well. However, the seat sensor had to be over ridden, not a fan of that but the comfort on my 1.5 acre Lake lot is Golden!

Absolute game changer. Installed on hustler zero turn. Like riding on a cloud. I'm 230 lbs and was able to adjust for perfect ride. HOWEVER was not a fun install. Straight out of the box, this cannot be installed on a flat plate/surface. No way, no how. For the suspension to work there is about 3/4" of travel required. Travel that allows the suspension system to collapse and flex below the mounting plane. My solution was to make standoffs. 4 x 3/4" spacers that are placed in between the suspension system and the plate on my mower. Also needed to get 4 x 3/4" longer mounting bolts. I used 1-3/4" long bolts. You could just stack fender washers to achieve this 3/4" gap under each of the 4 mounting bolts. Without that gap achieved by spacing, the suspension won't collapse and do it's job. It stinks because the suspension system makes the seat sit up like 3" higher. Then if like me, it's installed on a flat plate, you need to add another 3/4" so the seat sits almost 4" higher.

Bonne atténuation des chocs, pas aussi efficace qu’on vrai siege suspendu mais pas mal

Had to drill a few holes for it to fit a John Deere Z9 series . It definitely helps , but only about an inch of travel . so needs to be set (tightened) perfect for optimal performance.

yes it was tricky to say the least on installing this thing , ugh, tried my patience But worth it in the long run, it really does make a difference for my back . They need to include at least basic steps for instructions.

Exactly what I ordered! You are on your own to install! Very Very Very Poor Instuctions!!

Did not work on 50in toro zero turn had to make several adjustments by drilling mounting holes.