Klantbeoordelingen voor VEVOR MR-13A Boorbit Slijper 120W Boor Slijper 4500 RPM Slijpstation Stalen Boorbit Slijper 95-135° Verstelbare Punthoek 11 Spantangen Geschikt voor Boordiameter φ3-13 mm

Very nice sharpener and all I need for my uses. Would be nice if it could sharpen to a bit smaller sized bits, but it covers most of what I use. Better instructions are really needed. The grammer is terrible. The worst part is the section describing the placement of the pins for different sized bits in the 2nd step for tip splitting. There should just be a table saying where to set them for different size ranges of bits. Basically, it's just trial and error now. But, sill way better then anything else for twice the price.

This has worked very well for my needs. I struggle with the smaller bits by hand, I lost my sight recently, so this is helping a lot. I did find it finicky at first, the setting dial to set the drill up is not matching the size of the bit. Now I just leave it where it is ... which is halfway, pull the bit out and make sure it's level with the flats on the holder. I also had to adjust the in and out of the thinning / splitting on top. Once I did that, it's been perfect. The instructions are poor, but there are enough videos to get you started. I probably should have bought the larger grinder. I have not used the diamond yet, the CBN is perfect for HSS. None of my carbide drills have been sharpened yet.

Fungerar bra och enkelt att använda.👍

Works great

- Leider gibt es bei VEVOR keine Ersatzschleifscheiben. Grosses MINUS! - Gerät robust und zufriedenstellend - Motorleistung für grössere Bohrer etwas schwach - Kleine kurze Bohrer unter 4mm sind schwierig einzustellen - Lieferung in die Schweiz + CHF 26.- DHL + Zoll

Machines works great and have no complaints on it. Directions could be a lot better for some people that haven’t used a machine like this.

Seems to be a quality machine. I have not used it but one time to just check it out. One thing that surprised me was Vevor charged me a transaction fee for using Paypal in the amount of $7.52 along with the price of the machine.

The machine works and performs fine, and is not too difficult to use. However, the storage area for all the collets is very poorly designed - not only is there no latch on the door that overs the storage compartment, there is also no way to keep the collets in their holes and they can just fall out at any time.

Works ok but would be nice that ability to sharpen even larger drill bits. I'm not convinced on the angle gauge precision.

Did have lots of bad drill bits, did sharpen all of them and they are SHARP. i think did done about 40-50 and no wear/tear seen. VERY resonable price to get more life for ok drills