Klantbeoordelingen voor VEVOR Motorsteun, Motorhouder 680 kg, Motorsteun met klauwkrik en transmissiehouder, Motortakel voor autowerkplaatsen met wielen en 508 mm handgreep, Draagbare motortakel, Motorkraan, Reparatiegereedschap, Opvouwbaar

sturdy enough for my 3uzfe "old lexus v8" but its only about 430-480 lbs tops, and its drooping a little , wouldn't put anything heavier than that . granted it was cheap but it would never hold 1500lbs safely doing the job for now ,but wish i spent a little more on a better one

The engine stand was reasonably easy to put together, it's a decent design but the execution leaves something to be desired. The plate that the black arms bolt to was welded to the black cylinder slightly clocked, and the hole in the orange cylinder that it slides into was also slightly clocked, so the plate is quite angled when the pin is inserted. The picture shows how tilted the plate is when it's supposed to be horizontal. I can compensate for it somewhat by adjusting the arms, but it's still a bit annoying. Also, after rotating the engine, the pin is difficult to install again, the holes don't line up really well along the axis of rotation. Probably why the price was so good.

GOOD QUALITY, INSTRUCTIONS COULB BE A LITTLE MORE SIMPLE/CLEAR

Works as expected

Works like it should.It's hold the motor right now.So far about a week or two?Haven't got to it yet.I'll let you know how it performs in the end

This is a great engine stand fit perfect in my shop. We’ll buy another one if I need it.

Good overall but hard to get the pin back in when you rotate it but still a good buy

The Vevor engine stand is a great buy if you don’t need to hold up anything over a 4 or 6 cylinder engine. It’s rated up to 750 pounds and I’ve now had a fully assembled KA24DET on it and it worked fine. My biggest concern is the twisting portion of the stand. There is no barrier between the mount and the stand, makes it difficult to twist the mount and runs terribly in the inside of the stand. For the price point of $70, it’s not a bad little investment for your project!

acheté pour mettre un moteur 1,8l honda , supporte le poids , mais reçu sans la poignée pour faire tourner le moteur. arrangé avec le SAV

Fast shipping and good quality