Klantbeoordelingen voor VEVOR Motorfietswielblok, 816,5 kg capaciteit wielhouder, robuuste stalen motorfiets voorwielstandaard met 3 verstelbare gaten, voor 381-533,4 mm off-road motorfietsen, standaard motorfietsen

Well built, adjustable for different tire sizes and hold the bike upright and sturdy. I have a '22 Scout Bobber with a fat front tire and it fits in perfectly. I have installed it on my bike lift with some quickly removable hardware as it is rather large and the nose sticks out over the end of the hoist making for a great shin smasher. The one that came with the hoist (Ranger RML-1500XL) was utter junk and found it's way into the scrap bin, this is a perfect solution and priced right!

Arrived in the designated time. Great product and at a great price, easy to install and well made.

Reçu en temps et en heure mais arrive déjà abîmé avec manque de peinture et un peu piqué part la rouille donc decu

I have a 21", 90 width front wheel which is a little thin for this so doesn't hold the 250kg bike secure enough. I have a simple solution: kick down sidestand, put a little stone under it and done. No wind is strong enough to tip the bike like that. You can check it out on my youtube channel @onthepegs

Bon rapport qualité prix

Decent build quality, cones with the hardware to install , although I used larger washers, handled my KLR650 with ease.Can't complain for the price. Would recommend this unit.

I had to make two alterations to make this usable. I didn’t want to bolt it to the floor so I fixed a 600 mm long piece of 40 x 40 steel angle to the front. Some rubber strips under this stopped it sliding around and makes the whole thing very stable. With the bike in the stand, the shiny plastic coating on the base allows the tyre to ‘squirm’ sideways a lot and the bike is not held upright with any security at all. I overcame this by bolting two short 50x40 timber sections to the base in close contact to either side of the tyre wall. The tyre can’t move sideways and the bike stays vertical. Both these mods could be done by Vevor!

Round head bolts not ideal for the thickness of the metal, the square hole turned round on hand tightening, instead should have a standard bolt head so can be held in place with a tool.

I put my tent garage up and was very happy. I also made a stone foundation to anchor it well. After one week it was a windy weekend and the complete tent went to pieces. Too bad because the idea is brilliant.

Description says fit wheels up to 21 inches, but it doesn't. I tried all of the different settings on the wheel chock but the bike keeps wanting to fall.