Klantbeoordelingen voor VEVOR Mini koelkaststandaard 414 x 414 x 104 mm, universele wasbakbasis, verstelbare koelkaststandaard met soepele wielen, wasmachinebasis voor wasmachine en droger

A complete waste of money... Sorry VEVOR company, but after many items of quality, this one is a bust. The materials used, even though at first sight appear solid, but once when loaded with a washing machine on top, a complete disaster. The whole setup is just too wobbly, not to mention the fact when the washing machine goes into centrifuge mode! The materials for the legs and the stand are just too thing to prevent washing machine wobble. Try again Vevor!

Takes forever to assemble and needs to be modified if you want the drawer to be in line with the front (mounted as instructed it sticks out 1-2 cm). It feels sturdy but if you have a machine that vibrates/shakes a lot you should look for a pedestal with sturdier construction. I bought this because it looked much nicer than the ones I've had before that doesn't have a covered front, but they were much sturdier and isolated the vibrations. If your machine "walks" around when on the floor it will make this pedestal walk around as well. Was cheap though so can't really fault it, worth the price I guess but I would have paid more to get something sturdier.

Great quality for the price instructions could be a bit more descriptive and the size needs to be smaller to fit domestic front loaders as it’s much to deep for most household machines.

This is a great pedestal at a really good price. Unfortunately, the measurements in the pics are wrong. It is only 27" wide, and was too narrow for my 29" dryer. Also, the instructions have you install the top part with the lip facing upwards, but the pictures shown have the lip facing down. I tried it this way to see if I could make my dryer work, but I don't want to have it balancing on the edges off this, 14" above the ground.

Whilst the unit itself feels solid, the frame is too big and the width of the rails it sits on are too thin. I had to buy a plate to put on top so my washing machine didn't fall off the frame. I really don't understand why the rails are so thin. The draw when pulled out to get something at the back falls off it's left rail but remains on the right. My machine should have fit, we did measurements, not sure if I got this wrong thinking the rails would hold the footing of the machine.

It went together easily until it was time to install the drawer. I aligned the slider ends and pushed the drawer in and all the guts and bearings fell out of the inside of the slider on one side. I'm going to have drill out the rivets and replace the sliders with something better.

Not sufficiently well engineered to cope with the weight of a loaded washing machine in operation. Vibrates badly.

Not working as advertised