Klantbeoordelingen voor VEVOR Metaalzaag, Verstekzaag, 355 mm zaagblad, 2800 W motor, voor het zagen van metaal, instelbare hoek van -45° tot 45°, droog zagen, met zaagbladbescherming en spaanopvangbak

Ich bin mit der Metallkappsäge vollstens zufrieden. Zu 99.9 % fungenfreies Metall sägen, ebenso fast gradfreies abschneiden.

Fantastic for hobby users!! This is already paying for itself by saving the "cut" premium for short 2020 aluminum extrusion. I was building something and the 700mm lengths and 100mm lengths were the SAME price, sometimes more. So by buying longer and cutting I'm saving a ton. The clamp is great, similar to the dewalt I used to have before I sold it to move to a small house across the country to be close to family. The power is weak but with the blade size seems adequate. The blade cuts great. The only issue is the guard kinda sucks and needed some adjustment to actually work as a guard (loosen screw, bend it to not rub). I haven't tried steel yet, but blade speed is perfect, and not just a wood saw with a metal blade so with the right pressure I suspect this will cut steel just fine. But for aluminum 2020 it is fantastic (I didn't want to use my compound mitre saw I'm using for renos for aluminum and find metal bits in my oak trim).

Super Säge. Habe schon einige Stäbe gesägt und funktioniert wie zu Beginn. Drehzahleinstellung trägt seinen Teil dazu bei!

It works the same as a $600 table saw. I use to cut 1 1/4" aluminum tube 1/8" thick. It does the job so clean and as the knife go through the cheese! so light and portable. well worth it. A greater purchase than the cost!

Para o preço que custa não se pode exigir mais. Media qualidade. Faz bons cortes a baixa rotação

Works fine, swift delviery

Great price, great for DIY projects at home. Simple to setup and use.

after a drawn out process, I now have a working saw. To be fair, Vevor support was very good, but the language barrier did not help. To sum up, the first saw was shipped with a 110V plug, and it quit when I tried a test cut. The saw was replaced with a refurbished one (likely failed for same reason and repaired) but had a 110V plug, AGAIN. This is a 220v saw people, it is written on the motor plate, and in hindsight, I should have trusted it. If you run it on 110v, the saw will only reach 750 rpm, and the variable speed is ineffective. They ultimately allowed me to cut the end off, and install a proper, 220v I purchased myself (rather than waiting two weeks for a new cord) and maintain the warranty. Thank you Vevor, but it was a long process.

it is 240 volt with a two prong cord which was unable to work for my application. rep was able to resolve my issue and was above and beyond to help.

was building a small utility trailer saw cut thru mild steel fine ,the adjustable angle support was a little weak but i was able to use it ok