Klantbeoordelingen voor VEVOR magnetische boormachine, 1550 W motor, magnetische boor met een kernboordiameter van 50 mm, 13000 N magnetische kracht, snelheidsregeling 0–550 tpm, kernboormachine voor metalen oppervlakken, doe-het-zelfbenodigdheden

TODO PERFECTO

Parfait j'ai pus réaliser des perçage sous des tubes suspendus, donc perçage à l'envers aimant accroché par sécurité avec une sangle, en cas de coupure de courant. Trous diamètres 55 mm dans du tube de 160x80x3 mm , les 20 trous en moins de 2 h c'est une très bonne machine pour un prix vraiment compétitif. Bravo

Parfait, puissance au rendez vous, j’ai percé, 30 trous dans de la tôle de 1 cm. La machine a fait le travail correctement sans sourciller.

WOW, this thing rocks, I am building a bridge for myself, I used in the middle of my property on a generator, it locked onto the steel beams, I couldn't budge it, I used the handle to pull myself up more than a few times. My biggest problem was the cooling system, it never worked right, I did it manually, it was a little bit of a bitch, but it was fine. 80 1/2" holes in Steel I-Beams, took my time, I would buy it again, best money I've spent in a while, and I can use it again, and will when I need to...

Good design. Says “50H” on mine. Runs at 120V/60Hz. Measured 670 RPM no load. Gear ratio: 25.06:1. Zero internal electronics (no soft start circuit) or SCR speed dimmer - WYSIWYG. Power was properly grounded to the body. I like that the carbon brushes are easy to access. The internal fuse wire was a bit exposed but easy to fix. It’s a super simple drill with decent gearing. Use with a VFD instead of getting a speed-variable one if you understand how universal AC motors slow down and keep torque.

100 gasten geboord in stalen balken van 10mm dik. Moeiteloos in combinatie met goede boor olie.

Top Produkt zum top preis. Kann ich jedem empfehlen. Funktioniert sehr gut. Lg aus Österreich

Perfect apparaat voor een redelijke prijs

usato per forare travi in ferro all'inverso ottimo trapano

I bought this thing almost 4 years ago, works like a champ. I have only two issues with it, neither that would make me not but it again, but, the lubrication method for the head and the spring loaded pin for slug removal isn't much and causes a huge mess with excessive oil consumption and then there's the noise the motor makes. I suggest wearing earplugs, I certainly do. Other than that, I use mine all the time from overhead to horizontal without any issue. I would definitely buy it again for the price I paid. It's paid for itself a long time ago.