Klantbeoordelingen voor VEVOR magnetische boormachine, 1550 W motor, magnetische boor met een kernboordiameter van 50 mm, 13000 N magnetische kracht, snelheidsregeling 0–550 tpm, kernboormachine voor metalen oppervlakken, doe-het-zelfbenodigdheden

I am a retired millwright of 47 years and was asked by a friend to build some grain bin jacks. I accepted the job but needed a mag drill to do the job. Milwaukee was priced at over a thousand dollars so I checked out Vevor priced at 200 bucks and was pleasantly surprised by the quality of the drill it drilled me a hundred holes mostly 5/8” to 1” . Plenty of power and the electro magnet was very strong. I would buy the drill again. Very satisfied !!!

Produit ok n'a rien a envier aux marques pro. Puissante, un aimant qui accroche bien. Ne peux être activée en rotation si pas activée en magnétique: donc bonne sécurité.

This is the first mag drill Ive ever used, but very inpressed. I recently used this drill to make a welding fixture table. It worked great I drilled roughly 120 holes through 1/4 plate with a 5/8 annular cutter, and it took me maybe 3 hours. I gave 3 stars for quality because the tool arrived with a damaged glad hand electrical connector. Vevor responded quickly and sent a replacement part, so very good customer support. The rest of the drill seems to be of good quality and very heavy duty.

Cannot use the chuck! Adapter is too small to screw the chuck onto! ADAPTER is 3/4-1/2"-20 UNF But the chuck is 3-16mm M18x1.5! I need either a larger Adapter to fit the metric chuck or a smaller chuck to fit the standard Adapter!

After having for a month , magnetic clamp works great. Well built only drawback is one speed only. Odd when cutting plate one prefers slower speed to keep bits sharp. If you can spend a little more get the speed control. More control in the cut

Con lowest speed doesn't maintain constant speed. 3 or higher does fine. Head needs a position hold of some sort as it goes down by gravity. Pro. Drills like crazy good magnetic hold and makes an enormous amount of chips. Be ready for that. Made a mount to attach on my drill press abd use it for larger holes. Definitely would purchase again.

Die Maschine ist sehr gut, nur negative ist, das man die Spindel nicht in der oberste Stellung fixieren kann. Das macht den Bohrer Wechsel zum Erlebnis

Drilled 32 1.1/16" through 5/8" think on its side . Used dark threading oil with TCT bit . Magnetic held way better than my old black&decker . Would recommend but this particular one is heavy but the variable speed is nice this one is the 1680w o-300 rpm will not drill as slow as was hoping but still did good have some 1.11/16" holes to drill will check back in

so with oiler head in place by time i add bit not enought room took apart flipped back plate and tracks now can use reguler drill bits and metal hole saw do fell magnetic was stronger beats hearting arm drilling chain pots in steel plate

La perceuse comme tel va très bien mais les passe fils vissé sont de très mauvaise qualité, l'aimant n'est pas hyper fort non plus.