Klantbeoordelingen voor VEVOR Laswagen 2 planken met 4 lades Lasmobiel Max. 100-120 kg Wagen voor lasapparatuur met 2 gasfleshouders Ideaal voor handmatig lassen, lassen met afgeschermd gas, argonbooglassen

All in all nice little cart for the money. Assembly was a bit timely but not too bad.

Alles in Ordnung, kann man kaufen

For the price it's a goos product the only downside is the drawers don't fit well.

ESTA BIEN UN POCO BAJO PERO POR LO GENERAL BIEN

Perfect fit, the drawers are great! Makes it so much easier to stay organized

The cart's ok for the price; obviously you're not paying top-tier price nor getting a top-tier product. It goes together well, everything including drawers fit together as they were intended. I have a 200A unimig MIG welder, going by the published dimensions it should have been fine but it just barely fits on top of this cart. The gas line is a little squished and I had to add some rubber underneath to stop the welder feet sliding off the lip of the top tray. I'm also a little nervous re. weight load: there's no way this thing could carry the rated 100kg around. The front castors are also pretty poor, will probably end up replacing those. I'd happily pay a little more for better quality, but that's a hard sell to most people I guess.

Great cart. Took a bit longer to assemble as the diagram indicated parts with identifiable letters but there are none on the parts and I had to reverse the direction of some of the bolts. The handle design makes it a pain to access the spooling on the buzz-box but overall, a happy purchase.

Sehr viele Schrauben, der Aufbau nimmt schon einige Zeit in Anspruch. Die Schubladen sind klein und gehen beim Schieben durch die Erschütterungen immer wieder auf. Leider passt der Automatik Schweißhelm nicht auf die Ablage. Nicht für das 5 in 1 Schweißgerät zu empfehlen.

Very sturdy and assembly was somewhat smooth, But I had to modify. After assembly and setting the welder in place, the side door could not be lifted to access the wire feeder or to replace a roll of wire. I had to remove the hook on the left side and cut off the rail on the left side above the tray

Poorly described, poorly packaged for assembly! Difficult to follow directions as nothing has numbers on it to clarify resulting in 50% assembly and had to take apart because it was wrong..then when almost done and putting drawers in the top drawer lost all the bearings and slide fell apart!! Pretty disappointing!! It could be about a foot taller as well....