Klantbeoordelingen voor VEVOR Koelmiddelterugwinningstank 30 lbs 400 psi Herbruikbare cilindrische tank Φ 250 x 390 mm Koelmiddelterugwinningstank Oranje Koelmiddelterugwinningstank gemaakt van HP295 staal

So far it seems to be a good tank. The paint job is less desirable. It seems to never dry. It’s always sticky to the touch and runs off if refrigerant oil drips on it.

Seems like a good tank that I’ll be able to use for a long time. Have used just a little bit. I thought it was a little on the expensive side. I have put a vacuum on the tank and it seems like that has held which is good.

Der Behälter ist qualitativ hochwertig verarbeitet und verfügt über die üblichen zwei Anschlüsse sowie über einen weiteren den ich für Vakuum ziehen benutze

Good quality tank. Came pre charged with nitrogen and held a vacuum without any issues. Shipping was slower than advertised, but it got here. My only gripe with this unit is that the top guard is too short to invert the tank without hitting the valves. I wish they would make that a little taller so you could invert the tank without having to use spacers and figure out the weight of the spacers.

smaller than a standard 50 lb cylinder, but couldn't see anything that tells you how much smaller. Without knowing true volume I only felt comfortable putting 35lb of refrigerant in this tank. Also valves aren't labeled liq/vapor so I needed to check. I sharpie labeled them on my tank which isn't avail now, but if remember correctly blue is liquid valve for this tank. I have a few cylinders that have blue labelled liquid and a few with red labeled liquid, so no confidence in knowing which is which unless they are labeled liq and vapor from the MFR. Tank seems decently built and price is great, just could use some liq/vapor markings and a bit more volume to be a true 50 lb cylinder,

Purchased two for my business. Standard tanks. Dislike the ball valve on the side but other than that seems fine.

Die Flasche wurde schnell geliefert. Nachdem ich die Transport-Stickstofffüllung abgelassen und die Flasche vakuumiert hatte, habe ich aus Spaß einen Dichtigkeitstest mit Formiergas gemacht. Leider nicht so positiv. Alle Verschraubten Teile waren so undicht, dass mein Messgerät bei mittlerer Empfindlichkeit bis zum ANschlag ausgeschlagen hat. Nachdem ich alle verschraubten Teile mit Dichtmittel eingesetzt hatte und den Anschluss für den Füllstandsensor mit einem Stopfen verschlossen habe, ist die Flasche nun nutzbar und dicht.

started leaking at the valves shortly after

When the tank gets hot, the orange paint on top starts to "melt" off, and it gets really sticky and gets all over your fingers and clothes.

This company has been nothing but nonstop marketing to my phone and email despite not subscribing and unsubscribing. So this 30 lbs tank comes with 25 lbs of harassment. Be advised.