Klantbeoordelingen voor VEVOR Kabelstripmachine Elektrische kabelstripmachine van 1,5-40 mm, 370W stripmachine, 11 stripkanalen, striptang met kruk, 65Mn veerstalen blad, ideaal voor het strippen van koperdraad

This is the lower end of the wire strippers but it does the job well once you figure out the ideal position for the cable. The instructions are vague so the bottom line is the cable needs to be lower than the cutting point

Tolles Maschine. Wenn die Einstellung richtig gewählt ist knackt sie die härtesten Umhüllungen. Für starre und flexibele Kabel in jedem angegebenen Durchmesser geeignet. Leider kein Rückwärtsgang für ev. eingeklemmte Kabel.

Funktioniert.

That machine works very well and as intended. What I don't like is the instructions. The only reason I knew I needed to install the vent for the gear box was after reading about it on another review. NO where in the instructions does it inform what to do with the vent cap. More instruction on how to use the guide plates would be helpful also. I found that lowering the guide plate so the wire has to bend up to go over the rollers helped keep it in the "V" so the knife wheel cuts the sheathing as needed. I was just about to ask for a return until I tried it one more time since I have a lot of wire to strip. I am glad I did and was able to figure out how to mount the guide.

Works good. Takes a little getting use to and have to control the wire from rolling while stripping but well worth what I spent on this. Stripped 1000+ feet of 400amp wire

Apparaat werkt super. Het pellen van de kabel gaat echt super snel. Zat ook goed en stevig verpakt zoals te te zien op onderstaande foto.

Decent

Glad I bought this wire stripper. It has already paid for itself! So glad I got the automatic version, the hand crank on this is pretty hard to turn and get going. I could see manual for smaller wire maybe, but nothing large. It works really good once everything is adjusted, I spent a half a day messing around with centering the blades, moving the feeder ports up and trying to properly adjust the blade depth to cut the insulation all the way to the wire and not score the copper. Once it was all set though this thing is a dream for stripping.

Na menšie prierezy kábla to nieje vhodné, aj keď by to malo ísť. Od prierezu 16mm2 hore, to funguje skoro perfektne. Na VN káble do prierezu 240mm2 to funguje priam výborne. Jednu vec ľutujem, že som si to nekúpil ovela skôr. Dostalo to pri mne neskutočne zabrať, čakal som že to zlomím prvý deň a vydržalo to. Keď to pokazím, kúpim si ďalší ale už elektrický

Très bon produit reçu rapidement mais un peu déçu de ne pas avoir pu la tester tout de suite car la machine m’est parvenu casser