Klantbeoordelingen voor VEVOR 37,77cc benzine T-paalrammer, 4-takt benzine hekkenrammer met 3 paalkoppen (45/55/88 mm), draagbare 1000W palenrammer voor boerderijen, ranchhekken en wegverbeteringen

It was very old stock, stickers peeling off, carrying case warped, etc… but it did work as expected.

Très bien 👍

It works pretty well as long as the ground isn’t too hard. Difficult to find answers from technical support. When I first used it, it would not hit very hard. I watched a YouTube video and it showed the guy bangs on the piston to make it start hitting harder. It worked.

Bought this because i was building a fence in some rough country where i couldn't get a tractor, it drove the T posts in without a problem, It saved me from putting all the posts in by hand. Only word of caution is, eat your Wheaties before use cause it is a heavy piece of equipment

For the price you can’t beat it. It runs good. It will drive a t post into asphalt , that’s impressive. It’s best use is in hard ground, Or somebody that isn’t able to drive posts manually anymore. I have several larger tools from vevor and have been happy with them all.

This Vevor post driver works fantastic. I live in a very rocky area, it made light work of pounding tposts, also drove in 2 7/8 pipe with ease. 2 reasons I gave 4 vs 5 stars 1st - the choke signs are wrong, says off when it's on and vice versa. 2nd - the smaller attachment is a little big for a tpost which causes it to wobble. Making it hard to get the tpost started. This one is minor once I got it figured out they went quick.

Bought this to replace our similar gas powered driver. It works, but really struggles with our rocky clay soil. Its getting the job done, but its taking twice as long to get pasture fencing set with this driver. Should have went bigger I guess

Most everything i have bought from vevor has been pretty decent. However, this product did not meet expectations. I can drive a t post faster and easier than using this 4stroke post driver. It also started spitting oil out from around the valve cover on the first test run after adding its first bit of oil and gas to it. After looking into it, it appeared the valve cover was cracked at the threaded hole where the body cover screws to it. I put rtv on the inside and outside of the crack, and it seems to have fixed it. Overall, it just doesn't pack enough umph to drive the t post very well. It might in fresh tilled soil, but putting fence post in loose dirt like that is not a good idea. If i had to do it over, i would have just bought a manual post driver and saved a couple hundred dollars, because i still have to use one on most all the post.

The driver is extremely light which is nice and starts easily but, it is not a good driver. Parts are cross threaded and it has no power to drive practically anything. It struggles to get a simple tpost about a foot in sand. Also, the instructions are horrible.

Does not work in hard soils