Klantbeoordelingen voor VEVOR Handmatige Tegelsnijder 35-600 mm, Tegelsnijmachine, Tegelsnijder Snijdikte 6-15 mm, Extra Snijwiel, Keramische Vloertegelsnijder, Laserpositionering, Enkelspoor 6 kg

Prodotto conforme alla descrizione, i materiali ad un primo utilizzo sono di buona qualità

It did the job. Took a bit of fiddling lining up the laser light with the cutting wheel but got there eventually.

This work better than I thought. I had to make a few adjustments to get a nice square cut. the laser site is pretty handy. good for the price

Loved the 24" tile cutter and it worked beautifully with one exception. The tubular cover at the top of the centre line is a little too high and the tile does not sit comfortably when cutting. Would I buy it again - Yes.

Clean cuts every time. Instructions could be better for the attachment of angle accessories. Laser light difficult to line up with score wheel accurately but overall very happy.

It cuts so easy , a D.I.Y must have . handles 600mm porcilian tile easily, straight and clean.the only problem I have with it is the cutter is not aligned straight and dose cut straight unless you mark at each end of the tile and make sure it`s going to those marks. I tried to realign the rail and got it to within a couple of mm and it is a pitty that I cannot just put a tile in and just cut it instead of fiddling around linnig up marks because the Rail is not square to the cutter.

The laser light is not neat enough and incorrect guidance. So it make the cutting edge was not correct as required. The balance of the device is not good when putting the tile on to cut. You have to hold the tile firmly when cutting

Handhabung und Schneideleistung ist sehr gut. Nur der Anschlag, passt nicht zum Gesamtbild. Die Winkelverstellung und die Position vom Anschlag verstellt selbständig, leider

I have been using this to install 60cmx60cm large format tiles during the last month. I had to struggle so much to get the laser pointing straight. It is not properly fitted when illuminating straight (what it is supposed to do). There is also a slight non-adjustable cut that results in non-straight cuts. When cutting 60cm tile, this leads to around 2mm error which is impossible to correct. I hope that Vevor will fix this design error as I read about this error before I bought it. I thought it could have been fixed by the time I bought it about 3 months ago. No, I was disappointed. Yet, for the price I paid, I still got my job done and I am happy with it. But, Vevor has to fix this issue.

I like the laser showing the cut to do. The rules on the right side doesn't really help to cut with angle but the rest is excellent