Klantbeoordelingen voor VEVOR 63CC 2400W benzine grondboor met 8-inch kernboren en 1 verlengstang, paalhekgatengraver voor landbouwgrond, tuinplanten, oranje + zwart

Junk fired up and it was wide open without my hand on the throttle and grabbed my pants and before I new it we were both on the ground my legs got twisted up like a twisler I was fighting for my life to hit the kill switch

Worked well for the project I bought it for, but the next time I tried to use it it had a major malfunction. The off switch literally doesn't work. It will just stay on until it runs out of gas. Because of this, it's effectively unusable.

Thie machine is very well made and easy to use. Unfortunately, the engine size lacked enough power to work in the clay soil in my area.

It broke after first use and I had to repair the winding coil for the starter cord. It's a beast - really loud, smelly, and loose parts. If I had to decide again, I would buy a higher quality auger elswhere.

can't get no parts for it and the pull cord mechanism broke the spring in the start cord after using it 5xs

Les prix sont intéressants ,par contre difficile en cd de panne Un lanceur qui bloque au troisième trou ,pas de service après vente et aide technique digne de ce nom !! Pas de pièce détachée Je réfléchirai la prochaine fois

Works great when it works. Like the bog down and not rev out, causing a substantial lack of power do not recommend this

Voulant me faciliter la tache du fait d’avoir une soixantaine de trois à faire, j’ai acheter ce matériel. Au premier démarrage ralenti très instable mais ajusté avec quelques tours de clefs. Premier trou impeccable et deuxième trou, le câble d’accélérateur casse net alors que je n’avais aucun point dur en accélérant. Bref, un achat qui ne m’a servi à rien car nous étions un dimanche donc impossible de remplacer le câble. j’ai fait les 60 trous à la pelle bêche ce dont je voulais à tout prit éviter pour un gain de temps. Qualité du câble et de la poignée d’accélérateur déplorable.

I bought this ager to dig post holes for my fence and I t was working fine until the 12 hole the shaft wouldn’t spin EVEN when I pulled it out of the hole. It sounded like something was slipping. I contacted the warranty people n they wanted me to send them a video of the issue which I did and they told me that they forwarded it to the right department for review. That was like 2 weeks ago and I still have yet to get an answer. I still have other holes to dig but this is stopping me from completing the job. Bad customer service. I just want them to either send me a new one or refund me. Just give me an answer

Unable to return my item.