Klantbeoordelingen voor VEVOR Grasmaaiermes Slijper, 15°-45° Verstelbaar, Grasmaaiermes Slijper met 4 Adapterpennen, Kogellagerontwerp en 25 mm Vergrote Handgreep, voor Gebruik met Haakse Slijper

The screw that tightens the blade doesn't stay right unless I'm holding it tight. The vibrations loosen it almost immediately and the blade drops right out after just a couple of passes. It maintains the angle well, but I had to set it to 45° to match the 33° angle it's supposed to be. I guess you get what you pay for.

Decent device for sharpening blades. No instructions came with it so it’s best to watch some videos. The head where the blade in has some slop in it. Has the grinder moves up the blade, the head pivots inward a bit. Not a huge deal but could definitely be better. I think some shim washers will correct this. The balancer is easy to use and seems to work correctly. If I was maintaining multiple machines I’d buy an actual bench mounted blade grinder. But, for what I do this works well. My blades did cut much better after the first use of this. I was happy with the results

Not big enough for zero turn blades Does not open up far enough for the blades on Arens and Gravley zero turn mowers

The base unit mount to the table is very good. The angle adjustment is lacking, only using a small thumbscrew to hold it. It is wobbly and prone to backing off with repeated sharpening. The blade mount opening is insufficient for commercial blades as it is JUST barely big enough to hold them in place with the retaining screws fully backed off. The arm mechanism would benefit from strengthening, it has too much flex when grinding into severely dulled blades. The spacer guide needs a more secure mechanism than a nut, the nut wiggles loose and then you're liable to hit the arm with the grinding wheel. The overall design is adequate but has a lot of room for what I can only imagine would be cheap manufacturing upgrades.