Klantbeoordelingen voor VEVOR geleiderail voor handcirkelzaag, inclusief 4 x 700 mm aluminium cirkelzaagrails en 3 verbindingsstukken, compatibel met diverse merken invalzagen, voor houtbewerkingsprojecten.

Gutte Anpassung mit Dem Tauchsäge Zufrieden mit dem Produkte von Vevor. Gute Produkte .............

good quality , fantastic value!

This rail is way cheaper than an original makita rail but it wasn't perfect. The stripes attached for glide and splint protection were partly lose and too long. I had to reattach them by pressing the rubber hard against the double sided tape and after I also had to cut them down at the sides so all prices could lay flush against each other.

Track is rigid enough but the ends were not cut perfectly square, you need to hold a straight edge against the track when assembling.

Convient pargfaitement pour une scie plongeante Festool. Seul petit bémol, les bandes de glisse mériterait un adhésif plus puissant

tracks they are very low quality. The edges do not line up square. The rubber edges and the red slides fall off the guides . The worst part is that due to incorrect square cut when all together it’s not a straight edge.

O encaixe das réguas não fica 100% direito!

The tracks are missing some of the set screws so it’s impossible to put them together right out of the box. All the anti slip tapes are peeling of and are misaligned. Contacted the seller and haven’t heard back from them yet.

I’ve only had the tracks for a couple of weeks. Very dissatisfied with the quality. The rubber pads on the back of all of them have come loose. I would not recommend them.

les connecteurs ne sont tout à fait à dimension du rail alu, donc il y a du jeu. Une fois les connecteurs montés et serrés, difficile d'avoir un linéaire parfait. Dommage, c'est quand ce que l'on demande pour un guidage.