Klantbeoordelingen voor VEVOR Garagevloerbeslag, 305 x 305 x 13,4 mm, 50-delige industriële vloerset, antislip dubbelzijdige getextureerde garagevloer, voor garages, kelders, reparatiewerkplaatsen, grafietgrijs

Perfect for basement floor, look clean and easy to clean.

Pas encore installer, mais ça a l’air de tenir la route. Seul regret, j’ai trouvé la même chose, marque VEVOR vendu sur un autre site et 15% moins cher! Là je me demande pourquoi?? Mais rapidité d’expédition….. Content de mon achat même si plus cher!

Montage instructies mogen duidelijker. Bij warmte zetten de tegels behoorlijk uit. Kwetsbaar als er iets op valt.

Soweit ganz ok, einfach zu verlegen, leicht zu bearbeiten . Etwas laut beim begehen, ich habe meine Hobby- Kfz-Werkstatt damit verschönert und darunter 3mm starken Gummikork gelegt. Super zum Reinigen .

Great product. Easy to install. The only issue I have is the variation of colour from batch to batch and that there is no edge or ramp section available to complete the floor. I will have to make a ramp for the entry to my garage.

Material com boa qualidade e de fácil instalação. Chegou bem embalado, embora tenha chegado muito depois do previsto

The biggest plus for me is the finished look you get with zero prep needed for the old cement garage floor. I installed over 600 sq feet of these in a garage and it took a while but the finsihed product was worth it. My biggest concern was not having the time or patience to fully prep a 30 year old cement floor properly to do a different type of flooring. I did crack a few panels installing them and also cutting these takes time to get it correctly done.

Really nice product and easy to install. Looks really sharp. The only bad thing I find is they are loud to walk on. They are east to clean as well.

Good quality tiles, easy to install. Some of the tiles were damaged while shipping and when garage is open the 1st 2 rows of exposed tiled buckle from heat of sun light. I am very pleased with the product over all.

Great price and very easy to install. They look good but seem to be a bit thinner than you might want - and may damage if you drop a heavy tool on one(?). Now that I am typing this, I may decide to test the scraps I have left over - but should have done that when we had a cold snap last week. Also not sure if they will support a loaded up floor jack. I have a car lift so I likely won't need to use my jack much. I rolled my heavy tool chest on it, and the wheels don't seem to be sinking into the tiles so my weight concerns may not be valid(?). Also, Vevor currently don't offer any edge pieces. It would be good to be able to finish the edge but so far I have been driving my heavy SUV over the unfinished edge and it is handling that very well. I have a fairly rough old concrete slab below, and I didn't want to spend a ton of time making it perfect for the tiles to lay on - and I first tried putting a section together on the slab. Walking on it didn't fee that good, as it moved up and down a bit, and made some slight grinding noises as only certain sections of the bottom tile support grid would contact the slab. I then bought some cheap linoleum to use as a sub floor and that seems to have made a big improvement.