Klantbeoordelingen voor VEVOR Magnetische Boorkernboormachine 1400W φ50mm, 12500N Draagbare Elektrische Magneetboormachine met 11 Kernboren, 800rpm Boor voor Metalen Oppervlakten Industrie DIY Geel

Drill works as expected, however I found that the magnetic base gets hot when using it to hold the unit on 90 surfaces. Must use stubby drill bits when using the drill chuck.

The overall quality is decent for the price. There are three issues I've had:: 1. The electromagnetic function is weak in the front next to the chuck, 2. The auto oiler function works but leaks and the resivor is so thin it leaks, 3. The drill will fall straight down under its own weight, and im not sure if there is a way to tighten it. Other than that, it works amazing for the price. Don't think you'll go wrong if you're looking to use this in more hobbies than buisness use.

I find the magnetic isn’t strong enough Apart from that it works well

For the money it pretty good compare to more expensive brands. Cannot hold its self vertically, but if you are wanting to drill some holes horizontally its great. Motor is definitely lower quality but i have drill several holes in 1/4” this metal with easy

Preis, Leistung ist Super für diese Maschine. Vor allem dass sich die Drehzahl regeln lässt ist sehr gut. Mein Kaufargument war dass der Bohrkopf, auf dem Schlitten, sich auch noch mal zusätzlich verstellen lässt. Somit gab es bis dato noch keine Probleme, auch wenn man längere Bohrer in dem mitgelieferten Bohrfutter einspannt. Ich kann diese Magnetbohrmaschine nur empfehlen !

It is good for money. I was able to tear the magnet off when I used a 16 mm drill. But it may also be the fault of unsharp drill-bit. It has enough power.

This drill is good value. It's not operationally identical to one that is three or four times as expensive but given the price it's a real tool. I use the drill for stainless plate which means I'm running at the lowest speed setting. I think the speed control is a simple PID controller so when the teeth hit the plate, the PID tries to compensate by opening up a current gate. This results in the rpm being substantially higher than under no load. (I'm guessing about twice as fast but I have no measurements). Under load, the drill is probably turning too fast for my application but as long as I keep the pressure down to keep the material from work-hardening, I can get through 1/4" plate with only a minor increase in heart rate. As with other similar products, I wish the design engineers would give you just a little more room to land clamps on the magnet because you're often needing to clamp mag drills down to make the most use of them (in non-ferrous metals or small parts).

First impression good, made a small adjustment to side steel guides supporting drilling lathe due to a sharp top edge digging into the aluminium rail making small shavings. Once lightly rounded off, this was corrected preventing shaving generation. One particular element me having a 220V machine was the adjustable speed control. I suspect that the speed control circuit has been designed for 110V as any setting above 50% generate a chuck/motor speed way beyond reasonable speeds for drilling and coring. Actually lowest setting generate a speed to high for larger sized core bits. Have not investigated if a 110V/220V selector is available to change over. Beyond this, the machine and magnet works flawlessly.

Gute Tools Ich wurde weiter empfehlen. Kaymak

Had to drill hundreds of holes. worked great