Klantbeoordelingen voor VEVOR Lasdraaitafel 80W Laspositioneerder 1-12 RPM Manipulator 30 kg (horizontaal) / 15 kg (verticaal) Draaitafel 0-90° Kantelhoek KD200 Drieklauwplaat voor snijden, slijpen en monteren

Exelent. Thanks

Obrotnik jak za te pieniądze uważam jest wporzadku po dwóch dniach używania jestem zadowolony .

Neskutočne mi to urýchlilo zváranie. To či mi predtým trvalo 7h som mal hotové za 2h a to nehovorím o pohodlnosti.

Zeker Aanrader en snelle levering. Doet wat er verwacht word, afwerking kan beter. Prijs kwaliteit topper.

Kuvaksen mukainen Hyvin pakattu oli puulaatikossa kaIkki osat mitkä luvattu mukana Rahtiin meni se ylimääräinen 30 no olihan laatikko painava lähes 50kg Käyttötestit seuraa voi olla että joutuu hdastamaan pyöritystä mutta kokeillessa sai sen pyörimään niin hitaasti että juuri eroitti liikkeen jaksaako tuo sitten vääntää kun tulee kuormaa kappale pystöasennossa kyllä mutta miten käy kun kallistaa Jää nähtäväksi

Doing my research, I watched a few YouTube videos about this product. Like 1 other purchaser, mine arrived with the clear plastic cover that protects the timer broken in several pieces. Vevor should pack the loose parts in the crate more securely so that they are not able to move around in shipment & bump against the main part that is bolted down solid to the base of the crate. Other than that 1 small flaw, I like it a lot. I've only used it a few times, but so far so good. I used the foot pedal to activate it & squeezed the trigger on my MIG gun with my hand to weld. I'm waiting on a plug end that I ordered so that I can wire the unit to my welder to activate the welder once the unit starts turning (either by foot pedal or timer). This will make things easier.

Se ha pagado al primer uso. Excelente relación calidad precio, uso profesional Caldereria ligera.

Very pleased with our welding positioner. We have a now almost fully automated welding solution for our products allowing consistent perfection in our fabrication. The unit we purchased will move slow enough for even deep TIG welding while the smaller units would be a bit too fast for our operation. The ease of use makes our process an easily transferable skill across all our fabricators. We entertained much more expensive options prior to choosing vevor and are confident we made the best choice for our application.

Thank you very nice very fast response for me to receive

Pulled out of the box and the bushing for the worm gear for the tilt pulled the collar off and broke it. I'll have to make a new one. The key for the crank wheel was also missing. It had a peice of tape where it should have been holding it in. But otherwise doesn't seem badly built. Shipping box was good.