Klantbeoordelingen voor VEVOR draadsnijmatrijzenset met 4 snijkoppen, handmatige pijpdraadsnijder met snijmatrijzen van 1/2 tot 1-1/4 inch NPT, handgereedschap voor draadsnijden met koffer voor loodgietersreparaties

un producto que cumplen con las especificaciones que dicen todo muy bien cuidado como siempre

Tutto perfetto, consigliabile.

Tres satisfait!!

Excellent value, & Surprisingly Sturdy NPT threadmaker in compact case. Very competitively priced and easy to use. Pity VEVOR doesn"t offer BSPT threadmaker kits too!

I used it when I have a plumbing job using galvanized pipe

Apparaat was goed verpakt en onbeschadigd aangekomen. Voelt solide aan. Wat mij tegen viel was dat de gemaakte schroefdraad erg taps is. Je hoopt op een cilinder vorm. Wanneer je een fitting hierop wilt schroeven sla je meteen 2 slagen over. Dit vanwege de geringe diameter. Ondanks de teflon tape had ik een lekkage na het afdoppen. Tip : draai draad tot net voorbij de laatste tand en zaag daarna de 2 laatste stukje schroefdraad af. En minstens 6 slagen teflon tape gebruiken. En vergeet de snijolie niet!

This is not a tool to install a piping system, but it works if you need to thread a couple of pipe. You’ll need some muscles and a good bench wise though. threaded around twelve 1-1/4 diameter pipe ends up to now. It was hard but it worked. Thread quality was not the greatest but fine. Very good tolol for the price.

They work well. I used the 1" and 1/2" to thread black pipe. My only issue and doens't affect the threading. The retaining clip that holds the die in the holder doesn't seem to hold it well. So sometimes the die would fall out easily

Use these as my backup and they've got me out of a couple jams. Pretty much like rigid but cheaper.

Desempenha o seu papel muito bem, faz boas roscas em ferro e plástico só tem um se não se fizer rosca com a alavanca tem de agarrar bem a peça onde encaixa na alavanca enquanto faz rosca se não ela salta da base.