Klantbeoordelingen voor VEVOR Draadsnijmessenset, 1/2 inch NPT, 3/4 inch NPT, 1 inch NPT, Draadsnijder, Pijpsnijset met 3 NPT-snijmessen, Opbergkoffer voor gegalvaniseerde aluminium, ijzeren en koperen buizen

J’ai fait le filetage en 1/2 sur 2 tuyaux de chauffage en verticale, elle fait son job mais la tête sortait tout le temps de sa manche et faut le tenir…j’ai tester sur 3/4 en horizontal, ça va mais mais elle a eu un peu mal à faire le boulot reste à voir dans le temps

pas encore utilisé

This pipe threading kit is the biggest pile of junk I've ever seen!!! It is not only junk, but the threads it cuts actually strips one or two rounds of threads toward the bottom part of the thread length!!!!!! Should have just saved my time and money and purchased the Harbor Freight one, and we ALL know what quality that is!!!!!! Was looking to buy a Vevor table top lathe, but not now!!!!! Save your money, and frustration, and buy something of quality!!!!!!!!!!!

Product snijd niet

De gebruiker heeft geen schriftelijke opmerkingen achtergelaten.

This was a really poor product! More or less impossible to get a descent result.

no coustomer service

Purchased to thread 2" iron pipe. Very difficult. The dies broke on the first one. Replacement dies are not offered. Do not purchase this if you are going to use it on 2" iron pipe. I tried to return the item but so far have not been successful.

I needed to extend a black pipe line. I used threading oil and the first 4 or 5 threads were smooth to cut. Every other thread was a battle. My first attempt left damaged threads so I had to cut the pipe and try again. It seems like the metal shavings were preventing clean grooves from getting cut. I finally got to 7 grooves and the tool wouldn't go any further.

Can’t get the large die to release from ratchet handleeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeereeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee.