Klantbeoordelingen voor VEVOR Boorbit Slijper 120 W Boorbit Slijper 4500 RPM Slijpstation 45# Stalen Boorbit Slijper 95-135° Verstelbare Punthoek 18 Spantangen Geschikt voor Boordiameter φ3-20 mm

This sharpener works amazingly well, once you get the hang of getting the bits aligned in the collet chuck it's super quick and easy to get a nice sharp edge. The only downside is the instructions are horrendous so look on YouTube at operation videos. Would 100% recommend.

Works great! Wonderful value for money!

Works great! definitely will buy again

Ich bin sehr angetan von der Qualität, Verarbeitung und Anwendung. Ich würde den Bohrerschleifer wieder kaufen und kann ihn daher nur weiterempfehlen.

Slijpt Zeer Nauwkeurig en nog scherper dan ze nieuw uit de doos komen

One of the best Drill Bit sharpener I've owned.

Ich bin sehr angetan von der Qualität, Verarbeitung und Anwendung. Ich würde den Bohrerschleifer wieder kaufen und kann ihn daher nur weiterempfehlen.

This drill sharpener is a game changer for small shop, DIY, garage enthusiasts. It's rare to find a tool that 'just works' and does a great job. The features and ease of use get 5 stars. My only downsides are obviously the price but I can overlook that when I use it, because again it does a great job without alot of fiddling. The other is quality because very simple things like stickers (that are used for adjusting and set up) are actually moving on the tool, and not solidly fixed or glued down. Overall though still 5 starts.

I ordered this drill bit sharpener after watch a few reviews on YouTube. I followed the same videos to set the sharpener up and found the setup to be very easy. I grabbed a handful of dull drill bits and had the sharpened in a matter of minutes. The drill bit sharpener isn't the cheapest tool but it will be well worth it when I dull a bit and don't have time to run out a grab a new one. The drill bit sharpener absolutely puts a factory fresh cutting edge on standard drill bits. You won't be disappointed... I know I'm not!

Brúska je kvalitne spracovaná, perfektne brúsi. Pri tomto type nie je možné meniť rozteč kolíkov, keď sa robí zábrus vrtáku (horná diera). Ak by som si to všimol, kúpil by som asi drahšiu verziu, ale po odskúšaní mi to stačí takto. Drahší typ podľa obrázkov má predvŕtané diery na zmenu záražiek. Napriek tomu odporúčam. Kotúč na tvrdokov som ešte nepoužil.